RFM69W Datasheet, PDF (76/78 Pages) List of Unclassifed Manufacturers – ISM TRANSCEIVER MODULE

ADVANCED COMMUNICATIONS & SENSING
RFM69W
DATASHEET
7.2.2. Manual Reset
A manual reset of the RFM69W is possible even for applications in which VDD cannot be physically disconnected. The
RESET pin should be pulled high for a hundred microseconds, and then released. The user should then wait for 5 ms
before using the module.
VDD
Reset Pin
(input)
> 100 us
High-Z ’’1’’
Wait for
5 ms
High-Z
Module is ready
from this point on
Figure 40. Manual Reset Timing Diagram
Note whilst pin RESET is driven high, an over current consumption of up to ten milliamps can be seen on VDD.
7.3. Reference Design
Please contact your representative for evaluation tools, reference designs and design assistance. Note that all
schematics shown in this section are full schematics, listing ALL required components, including decoupling capacitors.
Figure 41. +13dBm Schematic
Page 76
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com