RFM69W Datasheet, PDF (13/78 Pages) List of Unclassifed Manufacturers – ISM TRANSCEIVER MODULE

RFM69W
FSTEP
FRC
BRF
BRO
FDA
Frequency synthesizer step
RC Oscillator frequency
Bit rate, FSK
Bit rate, OOK
Frequency deviation, FSK
FSTEP = FXOSC/2¹⁹
After calibration
Programmable
Programmable
Programmable
FDA + BRF/2 =< 500 kHz
-
61.0
-
Hz
-
62.5
-
kHz
1.2
-
300 kbps
1.2
-
32.768 kbps
0.6
-
300 kHz
2.4.3. Receiver
All receiver tests are performed with RxBw = 10 kHz (Single Side Bandwidth) as programmed in RegRxBw, receiving a
PN15 sequence with a BER of 0.1% (Bit Synchronizer is enabled), unless otherwise specified. The LNA impedance is set
to 200 Ohms, by setting bit LnaZin in RegLna to 1. Blocking tests are performed with an unmodulated interferer. The
wanted signal power for the Blocking Immunity, ACR, IIP2, IIP3 and AMR tests is set 3 dB above the nominal sensitivity
level.
Table 6 Receiver Specification
Symbol
RFS_F
RFS_O
CCR
ACR
BI
AMR
IIP2
Description
Conditions
Min
FSK sensitivity, highest LNA gain _{FDA = 5 kHz, BR = 1.2 kb/s}
-
FDA = 5 kHz, BR = 4.8 kb/s
-
FDA = 40 kHz, BR = 38.4 kb/s
-
FDA = 5 kHz, BR = 1.2 kb/s *
-
OOK sensitivity, highest LNA gain _{BR = 4.8 kb/s}
-
Co-Channel Rejection
Adjacent Channel Rejection
-13
Offset = +/- 25 kHz ^-
Offset = +/- 50 kHz ³⁷
Blocking Immunity
Offset = +/- 1 MHz ^-
Offset = +/- 2 MHz ^-
Offset = +/- 10 MHz ^-
Blocking Immunity
Wanted signal at sensitivity
+16dB
Offset = +/- 1 MHz ^-
Offset = +/- 2 MHz ^-
Offset = +/- 10 MHz ^-
AM Rejection , AM modulated
interferer with 100% modulation
depth, fm = 1 kHz, square
Offset = +/- 1 MHz ^-
Offset = +/- 2 MHz ^-
Offset = +/- 10 MHz ^-
2nd order Input Intercept Point
Unwanted tones are 20 MHz
above the LO
Lowest LNA gain ^-
Highest LNA gain ^-
Typ Max Unit
-118
-114
-105
- dBm
- dBm
- dBm
-120
- dBm
-112 -109 dBm
-10
- dB
42
- dB
42
- dB
66
- dB
71
- dB
79
- dB
62
- dB
65
- dB
73
- dB
66
- dB
71
- dB
79
- dB
+75
- dBm
+35
- dBm
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com
Page 13