RFM69W Datasheet, PDF (36/78 Pages) List of Unclassifed Manufacturers – ISM TRANSCEIVER MODULE

RFM69W
4.2.1. Transmitter Startup Time
The transmitter wake-up time, TS_TR, is given by the sequence controlled by the digital part. It is a pure digital delay which
depends on the bit rate and the ramp-up time. In FSK mode, this time can be derived from the following equation.
,
where PaRamp is the ramp-up time programmed in RegPaRamp and Tbit is the bit time.
In OOK mode, this equation can be simplified to the following:
Tx startup request
(sequencer or user)
XO Started and PLL is locked
ModeReady
Analog
group delay
5 us
TS_TR
0.5 x Tbit
1.25 x PaRamp
(only in FSK
mode)
TxReady
Transmission of Packet
Figure 17. Tx Startup, FSK and OOK
4.2.2. Tx Start Procedure
As described in the former section, ModeReady and TxReady interrupts warn the uC that the transmitter is ready to
transmit data
‹ _{In Continuous mode, the preamble bits preceding the payload can be applied on the DIO2/DATA pin immediately after}
any of these interrupts have fired. The DCLK signal, activated on pin DIO1/DCLK can also be used to start toggling the
DATA pin, as described on Figure 30.
‹ In Packet mode, the RFM69W will automatically modulate the RF signal with preamble bytes as soon as TxReady or
ModeReady happen. The actual packet transmission (starting with the number of preambles specified in PreambleSize)
will start when the TxStartCondition is fulfilled.
4.2.3. Receiver Startup Time
It is highly recommended to use the built-in sequencer of the RFM69W, to optimize the delays when setting the module
in receive mode. It guarantees the shortest startup times, hence the lowest possible energy usage, for battery operated
systems.
The startup times of the receiver can be calculated from the following:
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com
Page 36