RFM69W Datasheet, PDF (69/78 Pages) List of Unclassifed Manufacturers – ISM TRANSCEIVER MODULE

ADVANCED COMMUNICATIONS & SENSING
RFM69W
DATASHEET
6.5. IRQ and Pin Mapping Registers
Table 27 IRQ and Pin Mapping Registers
Name
(Address)
RegDioMapping1
(0x25)
RegDioMapping2
(0x26)
Bits Variable Name
7-6 Dio0Mapping
5-4 Dio1Mapping
3-2 Dio2Mapping
1-0 Dio3Mapping
7-6 Dio4Mapping
5-4 Dio5Mapping
3-
2-0 ClkOut
RegIrqFlags1
(0x27)
7 ModeReady
6 RxReady
5 TxReady
4 PllLock
3 Rssi
2 Timeout
1 AutoMode
0 SyncAddressMatch
Mode
rw
rw
rw
rw
rw
rw
r
rw
r
r
r
r
rwc
r
r
r/rwc
Default
Value
Description
00
00 ^{Mapping of pins DIO0 to DIO5}
00
00
See Table 21 for mapping in Continuous mode
See Table 22 for mapping in Packet mode
00
00
0 unused
111 Selects CLKOUT frequency:
* 000 → FXOSC
001 → FXOSC / 2
010 → FXOSC / 4
011 → FXOSC / 8
100 → FXOSC / 16
101 → FXOSC / 32
110 → RC (automatically enabled)
111 → OFF
1 Set when the operation mode requested in Mode, is ready
- Sleep: Entering Sleep mode
- Standby: XO is running
- FS: PLL is locked
- Rx: RSSI sampling starts
- Tx: PA ramp-up completed
Cleared when changing operating mode.
0 Set in Rx mode, after RSSI, AGC and AFC.
Cleared when leaving Rx.
0 Set in Tx mode, after PA ramp-up.
Cleared when leaving Tx.
0 Set (in FS, Rx or Tx) when the PLL is locked.
Cleared when it is not.
0 Set in Rx when the RssiValue exceeds RssiThreshold.
Cleared when leaving Rx.
0 Set when a timeout occurs (see TimeoutRxStart and
TimeoutRssiThresh)
Cleared when leaving Rx or FIFO is emptied.
0 Set when entering Intermediate mode.
Cleared when exiting Intermediate mode.
Please note that in Sleep mode a small delay can be
observed between AutoMode interrupt and the
corresponding enter/exit condition.
0 Set when Sync and Address (if enabled) are detected.
Cleared when leaving Rx or FIFO is emptied.
This bit is read only in Packet mode, rwc in Continuous
mode
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com
Page 69