RFM69W Datasheet, PDF (14/78 Pages) List of Unclassifed Manufacturers – ISM TRANSCEIVER MODULE

RFM69W
IIP3
3rd order Input Intercept point
Unwanted tones are 1MHz and
1.995 MHz above the LO
Lowest LNA gain ^-
+13
Highest LNA gain ^{-23 -18}
- dBm
- dBm
BW_SSB
Single Side channel filter BW
Programmable
2.6
-
500 kHz
IMR_OOK
Image rejection in OOK mode
Wanted signal level = -106 dBm
27
30
- dB
TS_RE
Receiver wake-up time, from PLL RxBw = 10 kHz, BR = 4.8 kb/s
locked state to RxReady
RxBw = 200 kHz, BR = 100 kb/s
-
1.7
- ms
-
96
- us
TS_RE_AGC Receiver wake-up time, from PLL RxBw = 10 kHz, BR = 4.8 kb/s
-
3.0
ms
locked state, AGC enabled
RxBw = 200 kHz, BR = 100 kb/s
163
us
TS_RE_AGC Receiver wake-up time, from PLL RxBw = 10 kHz, BR = 4.8 kb/s
&AFC
lock state, AGC and AFC enabled _{RxBw = 200 kHz, BR = 100 kb/s}
4.8
ms
265
us
TS_FEI
FEI sampling time
Receiver is ready
-
4.T_bit
-
-
TS_AFC
AFC Response Time
Receiver is ready
-
4.T_bit
-
-
TS_RSSI
RSSI Response Time
Receiver is ready
-
2.T_bit
-
-
DR_RSSI
RSSI Dynamic Range
AGC enabled
Min
-
-115
- dBm
Max -
0
- dBm
*
Set SensitivityBoost in RegTestLna to 0x2D to reduce the noise floor in the receiver
2.4.4. Transmitter
Table 7 Transmitter Specification
Symbol
RF_OP
Description
RF output power in 50 ohms
On RFIO pin
Conditions
Min Typ Max Unit
Programmable with 1dB steps Max -
+13
- dBm
Min -
-18
- dBm
-
ΔRF_OP ^{RF output power stability}
From VDD=2.4V to 3.6V
- +/-0.3 - dB
PHN
Transmitter Phase Noise
50 kHz Offset from carrier
868 / 915 MHz bands
-
-95
- dBc/
434 / 315 MHz bands
-
-99
- Hz
ACP
Transmitter adjacent channel
BT=0.5 . Measurement conditions as
-
power (measured at 25 kHz off- defined by EN 300 220-1 V2.1.1
set)
-
-37 dBm
TS_TR
Transmitter wake up time, to the Frequency Synthesizer enabled,
first rising edge of DCLK
PaRamp = 10 us, BR = 4.8 kb/s.
-
120
- us
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com
Page 14