KXCJK-1013 Datasheet, PDF (4/31 Pages) List of Unclassifed Manufacturers – Accelerometer Specifications

± 2g / 4g / 8g Tri-axis Digital
Accelerometer Specifications
PART NUMBER:
KXCJK-1013
Rev. 2
Dec-2012
Table 2. Electrical
(specifications are for operation at 2.6V and T = 25C unless stated otherwise)
Parameters
Units
Min
Supply Voltage (Vdd) Operating
V
1.71
I/O Pads Supply Voltage (VIO)
V
1.7
Full Power Mode(RES = 1)
Current Consumption Low Power Mode¹ (RES = 0) A
Disabled
Output Low Voltage (Vio < 2V)²
Output Low Voltage (Vio > 2V)²
V
-
V
-
Output High Voltage
V
0.8 * Vio
Input Low Voltage
V
-
Input High Voltage
V
0.8 * Vio
Input Pull-down Current
Start Up Time³
Power Up Time⁴
I²C Communication Rate
Output Data Rate (ODR)⁵
A
ms
ms
MHz
Hz
2.0
0.781
Bandwidth (-3dB)^{6 RES = 0}
Hz
RES = 1
Hz
Typical
2.6
135
10
0.9
-
-
-
-
-
0
10
50
800
ODR/2
Max
3.6
Vdd
0.2 * Vio
0.4
-
0.2 * Vio
-
650
3.4
1600
Notes:
1. Current varies with Output Data Rate (ODR) see table below.
2. For I²C communication, this assumes a minimum 1.5k pull-up resistor on SCL and
SDA pins.
3. Start up time is from PC1 set to valid outputs. Time varies with Output Data Rate
(ODR); see chart below
4. Power up time is from Vdd and IO_Vdd valid to device boot completion.
5. User selectable through I²C.
6. User selectable and dependent on ODR and RES.
36 Thornwood Dr. – Ithaca, NY 14850
tel: [phone] – fax:[phone]
www.kionix.com - [e-mail]
© 2012 Kionix – All Rights Reserved
567-4177-1212061351
Page 4 of 31