M0100-103-3-000 Datasheet, PDF (12/16 Pages) List of Unclassifed Manufacturers – 400W AC Powered Servo Drive

SV7 Technical Specifications (Continued)
CONTROLLER (CONT): All Models
INPUTS/OUTPUTS (CONT)
Y1 output: Optical Darlington, NPN/sinking, 30 VDC max, 100 mA max. Function: brake relay
Y2 output: Optical Darlington, NPN/sinking, 30 VDC max, 100 mA max. Function: motion or tach
Y3 output: Optical Darlington, NPN/sinking, 30 VDC max, 100 mA max. Function: fault
Note: outputs Y1-Y3 have a shared common.
Y4 output: Optical Darlington, sinking or sourcing, 30 VDC max, 100 mA max
Note: any output that is not assigned to a dedicated funtion is general purpose programmable.
Analog input: Single-ended. Range (resolution) is software selectable 0-5 VDC (10 bits), +/-5 or 0-10
VDC (11 bits), or +/-10 VDC (12 bits). Software configurable offset, deadband and filtering.
COMMUNICATION INTER-
FACE
SV7-x-Ax: RS-232 for programming and serial communications
SV7-x-RE: RS-232 for programming and serial communications, RS-485 for serial communications
SV7-Q-EE: Ethernet for programming and serial communications
SV7-C-CE: RS-232 for programming, CANopen for communications
SV7-IP-EE: Ethernet for programming, EtherNet/IP for network communications"
ENCODER INTERFACE
Differential line receivers for incremental encoder (A/B quadrature) feedback, up to 2 MHz. 400 cp
min to 32,768 cpr max (1600 quadrature counts min to 131,072 quadrature counts max)
AGENCY APPROVALS
RoHS
CE EN61800-3:2004, EN61800-5-1:2003"
Software for All Drives
Quick Tuner™
Used for setup and configuration of the drive. For more
information about Quick Tuner^TM, visit the Applied Motion
Products website.
Q Programmer™
Q Programmer^TM is used to create and edit stand-alone
programs for Q version drives. These programs can in-
clude multi-tasking, math, register manipulation, encoder
following, and more.
Si Programmer™
Intended for use in stand-alone applications, Si Programmer™ provides a user friendly, point-and-click, graphical inter-
face that doesn’t require any previous programming experience. Currently available on SV7 and BLuAC5 servo drives
only.
All software applications run on Windows 7, Windows Vista, XP, 2000, NT, ME, 98.
12