M0100-103-3-000 Datasheet, PDF (11/16 Pages) List of Unclassifed Manufacturers – 400W AC Powered Servo Drive

Torq_Ru_ee_comC_mur_env_de_es_d f_Mo_or_toS_rsV₍₂7₂₀a_Vt_M4_od8_elV_s) DC
250
200
150
100
V0250-214-B 60VDC Peak
V0250-214-B 60VDC Cont
V0250-214-B 48VDC Peak
V0250-214-B 48VDC Cont
V0200-214-B 48VDC Peak
V0200-214-B 48VDC Cont
V0100-214-B 48VDC Peak
V0100-214-B 48VDC Cont
V0050-214-A 48VDC Peak
V0050-214-A 48VDC Cont
50
0
0
1000
2000
3000
4000
5000
6000
7000
8000
More curves available at www.applied-motion.com
Speed (RPM)
SV7 Technical Specifications
POWER AMPLIFIER: All Models
AMPLIFIER TYPE
Digital MOSFET 16 kHz PWM
CURRENT CONTROL
4 quadrant d-q method
OUTPUT CURRENT
0.5 to 7.0 A rms continuous, 0.5 to 14 A rms peak (2 seconds max, I2t limiting)
INPUT POWER
24-80 VDC (external power supply required)
PROTECTION
Over-voltage, under-voltage, over-temp, motor/wiring shorts (phase-to-phase, phase-to-ground)
REGENERATION
No internal regeneration circuit. RC-050 external regeneration clamp may be required for applications
with high load inertia and/or rapid deceleration
AMBIENT TEMPERATURE 0 to 40 ºC (32 to 104 ºF), must be mounted to suitable heatsink with adequate ventilation
HUMIDITY
90% max, non-condensing
WEIGHT
10 oz
CONTROLLER: All Models
NON-VOLATILE STORAGE Drive configuration and Q program stored in non-volatile memory
INPUTS/OUTPUTS
X1, X2 inputs: Optically isolated, differential, 5 VDC, minimum pulse width = 250 ns, maximum pulse
frequency = 2 MHz. Function: step & direction, CW/CCW step, A/B quadrature encoder
X3 input: Optically isolated, sinking or sourcing, 12-24 VDC. Function: motor enable
X4 input: Optically isolated, sinking or sourcing, 12-24 VDC. Function: alarm reset
X5, X6 inputs: Optically isolated, sinking or sourcing, 12-24 VDC. Function: CW and CCW jog inputs
Note: inputs X3-X6 have a shared common.
X7, X8 inputs: Optically isolated, differential, 12-24 VDC. Function: CW and CCW limits
Note: any input that is not assigned to a dedicated function can be used for a home or registration sensor
or for program branching.
Continued on page 12
11