EPC1064V Datasheet, PDF (20/36 Pages) List of Unclassifed Manufacturers – Configuration Devices for SRAM-Based LUT Devices

Configuration Devices for SRAM-based LUT Devices Data Sheet
EPC1 and EPC1441 devices can replace the EPC1213, EPC1064, and
EPC1064V configuration devices. The EPC1 or EPC1441 device
automatically emulates the EPC1213, EPC1064, or EPC1064V when it is
programmed with the appropriate POF. When the EPC1 or EPC1441
device is programmed with an EPC1213, EPC1064, or EPC1064V POF, the
FLEX 8000 device drives the EPC1 or EPC1441 device’s OE pin high and
clocks the EPC1 or EPC1441 device. One EPC1 device can store more
configuration data than the EPC1064, EPC1064V, EPC1213, or EPC1441
device. Therefore, designers can use one type of configuration device for
all FLEX devices. In addition, a single EPC1 or EPC1441 device can
configure any FLEX 8000 device.
For multi-device configuration of FLEX 8000 devices, the nCASC and nCS
pins provide handshaking between multiple configuration devices,
allowing several cascaded EPC1 or EPC1213 devices to serially configure
multiple FLEX 8000 devices. The EPC1441, EPC1064, and EPC1064V do
not support data cascading. Figure 8 shows a FLEX 8000 device
configured with a single EPC1, EPC1441, EPC1213, EPC1064, or
EPC1064V configuration device.
Figure 8. FLEX 8000 Device Configured with an EPC1, EPC1441, EPC1213,
EPC1064, or EPC1064V Configuration Device
VCC (1)
VCC (1) VCC (1)
FLEX 8000 Device
"0"
nS/P
CONF_DONE
"0"
MSEL1
nSTATUS
"0"
MSEL0
DCLK
(2)
(2)
Configuration
Device
nCS
OE
DCLK
DATA
DATA0
nCONFIG
Notes to Figure 8:
(1) The pull-up resistor should be connected to the same supply voltage as the
configuration device.
(2) All pull-up resistors are 1 kΩ.
Figure 9 shows three FLEX 8000 devices configured with two EPC1 or
EPC1213 configuration devices.
20
Altera Corporation