MC80F0224 Datasheet, PDF (116/128 Pages) List of Unclassifed Manufacturers – 8-BIT SINGLE-CHIP MICROCONTROLLERS

MC80F0208/16/24
Preliminary
Function
Load HEX File
Save HEX File
Erase
Blank Check
Program
Read
Verify
Option Write
Option
AUTO
Auto Option Write
Edit Buffer
Fill Buffer
Goto
OSC. ______ MHz
Start ______
End ______
Checksum
Com Port
Baud Rate
Select Device
Page Up Key
Page Down Key
Description
Load the data from the selected file storage into the memory buffer.
Save the current data in your memory buffer to a disk storage by using the Intel Motorolla HEX
format.
Erase the data in your target MCU before programming it.
Verify whether or not a device is in an erased or unprogrammed state.
This button enables you to place new data from the memory buffer into the target device.
Read the data in the target MCU into the buffer for examination. The checksum will be displayed
on the checksum box.
Assures that data in the device matches data in the memory buffer. If your device is secured, a
verification error is detected.
Progam the configuration data of target MCU. The security locking is performed with this button.
Set the configuration data of target MCU. The security locking is set with this button.
Erase & Program & Verify.
If selected with check mark, the option write is performed after erasure and write.
Modify the data in the selected address in your buffer memory
Fill the selected area with a data.
Display the selected page.
Enter your target system’s oscillator value with discarding below point.
Starting address
End address
Display the checksum(Hexdecimal) after reading the target device.
Select serial port.
Select UART baud rate.
Select target device.
Display the previous page of your memory buffer.
Display the higher page than the current location.
Table 1. ISP Function Description
112
MAR. 2005 Ver 0.2