MA28139 Datasheet, PDF (24/34 Pages) Dynex Semiconductor – OBDH Bus Terminal

MA28139
DC CHARACTERISTICS AND RATINGS
Parameter
Supply Voltage
Input Voltage
Current Through Any Pin
Operating Temperature
Storage Temperature
Min
Max
-0.5
7
-0.3 V_DD+0.3
-20
+20
-55
+125
-65
+150
Table 2: Absolute Maximum Ratings
Units
V
V
mA
°C
°C
Note: Stresses above those listed may cause permanent
damage to the device. This is a stress rating only and
functional operation of the device at these conditions, or at
any other condition above those indicated in the operations
section of this specification, is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect device reliability.
Symbol Parameter
Conditions
Min.
Typ.
Max. Units
V_DD
Supply Voltage
-
4.5
5.0
5.5
V
V_IH
CMOS input high voltage
-
0.8V_DD
-
V_DD
V
V_IL
CMOS input low voltage
-
V_SS
-
0.2 V_DD
V
V_OH
Output high voltage
I_OH = -1.0mA
V_DD - 0.5
-
-
V
V_OL
Output high voltage
I_OL = 4.0mA
-
-
0.4
V
I_PDL
Input Pull-down current
V_DD = 5.5V, V_IN = V_SS
-25
-
25
µA
I_PDH
Input Pull-down current
V_DD = 5.5V, V_IN = V_DD
25
-
400
µA
I_PUL
Input Pull-up current
V_DD = 5.5V, V_IN = V_SS
-400
-
-25
µA
I_PUH
Input Pull-up current
V_DD = 5.5V, V_IN = V_DD
-25
-
25
µA
I_L
Input leakage current
V_DD = 5.5V, V_IN = V_SS or V_DD
-10
-
10
µA
I_OZL
Output leakage current
V_DD = 5.5V, V_OUT = V_SS
-30
-
30
µA
I_OZH
Output leakage current
V_DD = 5.5V, V_OUT = V_DD
25
-
400
µA
I_DD1
Static Power supply Current
V_DD = 5.5V
-
0.02
8
mA
I_DD2
Dynamic Power supply Current f = 1MHz, V_DD = 5.5V
-
6
20
mA
Notes: 1. V_DD = 5V ±10% over full temperature range.
2. Total dose radiation not exceeding 10⁵ Rads(Si).
3. Mil-Std-883, method 5005, subgroups 1, 2, 3.
4. All outputs are suitable for TTL/CMOS drive.
5. Electro-Static Discharge protection is provided for all pins.
6. Internal pull-up or pull-down resistors should not be relied upon for proper operation and/or termination of input levels
under all operating conditions without prior consultation with GPS.
7. Input and output leakage measurements are guaranteed but not tested at -55°C.
Table 3: DC Characteristics
24/34