DRM-24V80W1PN Datasheet, PDF (12/20 Pages) Delta Electronics, Inc. – Built-in active PFC and up to 90% efficiency

TECHNICAL DATASHEET
CliQ M DIN Rail Power Supply
24V 81.6W 1 Phase / DRM-24V80W1PN
Safety Instructions
 Vertical Mounting
 Horizontal Mounting
– ALWAYS switch mains of input power OFF before connecting and disconnecting the input voltage to the device. If mains are not
turned OFF, there is risk of explosion / severe damage.
– If the unit is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.
– To guarantee sufficient convection cooling, please refer to the following instructions to ensure sufficient clearance
around the device.
Vertical Mounting: 40mm (1.57 inch) above and 20mm (0.79 inch) below the device as well as a lateral distance of 5mm
(0.2 inch) to other units. In case the adjacent device is a heat source, the lateral distance will be 15mm (0.6 inch).
Horizontal Mounting: 40mm (1.57 inch) above and below the device as well as a lateral distance of 20mm (0.79 inch) to
other units.
– The external enclosure where the unit will be installed shall meet the requirements for mechanical, electrical and fire enclosure.
– Note that the enclosure of the device can become very hot depending on the surrounding air temperature and output load
connected to the device. Risk of burns!
– The main power must be turned off before connecting or disconnecting wires to the terminals.
– DO NOT insert any objects into the unit.
– Dangerous voltages present for at least 5 minutes after disconnected all sources of power.
– The power supplies are built in units and must be installed in a cabinet or room (condensation free environment and indoor
location) that is relatively free of conductive contaminants.
12
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (May 2016, Rev. 00)