DS1780 Datasheet, PDF (9/28 Pages) Dallas Semiconductor – CPU Peripheral Monitor

DS1780
The worse such accident would be connecting -12V to +12V; a total of 24V difference, with the series
resistors this would draw a maximum of approximately 24 ma.
The internal scaling factor depends upon the particular input. The +12V_IN, +5V_IN, +3.3V_IN, and +2.5V_IN
inputs are internally scaled such that the nominal value of the respective supply corresponds to 3/4 of full
range, or a decimal count of 192. The approximate resolution is thus equal to:
This is depicted below in Table 5.
LSb (V_NOM) ≅
4/3 VNOM
256
VOLTAGE/DATA RELATIONSHIPS FOR POSITIVE ONLY VOLTAGE INPUTS
(+12V_IN, +5V_IN, +3.3V_IN, and +2.5V_IN) Table 5
INPUT PIN
LSb WEIGHTING
+12V_IN
62.5
+5V_IN
26.0
+3.3V_IN
17.2
+2.5V_IN
13.0
(mV)
ADC RESULT (BASE
10)
0
1
2
3
4
•
•
•
190
191
192
193
•
•
•
252
253
254
255
PIN VOLTAGE (V)
0
0.063
0.125
0.188
0.25
•
•
•
11.875
11.938
12.0
12.063
•
•
•
15.75
15.813
15.875
15.938
PIN VOLTAGE (V)
0
0.026
0.052
0.078
0.104
•
•
•
4.948
4.974
5.0
5.026
•
•
•
6.563
6.589
6.615
6.641
PIN VOLTAGE (V)
0
0.017
0.034
0.052
0.069
•
•
•
3.266
3.283
3.3
3.317
•
•
•
4.331
4.348
4.366
4.383
PIN VOLTAGE (V)
0
0.013
0.026
0.039
0.052
•
•
•
2.474
2.487
2.5
2.513
•
•
•
3.281
3.294
3.307
3.32
The other two voltage inputs use a slightly different scaling technique, due to the nature of the PC voltage
they are monitoring. Because processor voltage (V_CCP) can vary to 3.6V, the +V_CCP1 and +2.5V_S/+V_CCP1
inputs are internally scaled such that the ADC result is 0h for a 0V input and the maximum value of FFh
is returned for a voltage of 3.60V. This corresponds to an LSb weighting of 14.1 mV.
The inputs can also be used to monitor a negative supply, such as -12V. However, a resistor ladder and
positive reference voltage (V_REF) must be used (see Figure 1) such that input voltage to the DS1780
swings between OV and +3.6V. Assuming the DS1780 +V_CCP1 and +2.5V_S/+V_CCP2 pins have infinite
input impedance and the V_REF is a perfect supply, then the resolution and range of -12V input are:
LSb (R₁, R₂) ≅
3.6
255
é R1 + R2 ù
êë _R1
9 of 28