|
BCM43903 Datasheet, PDF (29/87 Pages) Cypress Semiconductor – WICED™ IEEE 802.11 b/g/n SoC with an Embedded Applications Processor | |||
|
◁ |
BCM43903 Preliminary Data Sheet
SPI Flash
SPI Flash
The SPI flash interface supports the following features:
⢠A SPI-compatible serial bus.
⢠An 80 MHz (maximum) clock frequency.
⢠Quad I/O, which provides increased throughput to 40 MB/s.
⢠Support for either Ã1 or Ã4 addresses with Ã4 data.
⢠3-bytes and 4-byte addressing modes.
⢠A configurable dummy-cycle count that is programmable from 1 to 15.
⢠Programmable instructions output to serial flash.
⢠An option to change the sampling edge from rising-edge to falling-edge for read-back data when in high-
speed mode.
UART
A high-speed 4-wire CTS/RTS UART interface can be enabled by software and has dedicated pins. Provided
primarily for debugging during development, this UART enables the BCM43903 to operate as RS-232 data
termination equipment (DTE) for exchanging and managing data with other serial devices. It is compatible with
the industry standard 16550 UART and provides a FIFO size of 64 Ã 8 in each direction.
There are two low-speed UART interfaces on the BCM43903. Each functions as a standard 2-wire UART. They
are also enabled as alternate functions on GPIOs and can be enabled independently of the 4-wire fast UART.
Broadcom®
March 12, 2016 ⢠43903-DS102-R
BROADCOM CONFIDENTIAL
Page 28
|
▷ |