HCPL-2533 Datasheet, PDF (8/11 Pages) AVAGO TECHNOLOGIES LIMITED – LSTTL compatible

Electrical Specifications
Over recommended temperature (T_A = 0°C to +70°C) unless otherwise specified.
Parameter
Symbol Min. Typ.* Max. Units Test Conditions
Fig. Note
Logic High
Output Current
Logic High
Supply Current
Input Reverse
Breakdown Voltage
I_OH
0.5
nA
T_A = 25°C,
55
I_F1 = I_F2 = 0 mA
V_O1 = V_O2 = V_CC = 5.5 V
50 µA
I_F1 = I_F2 = mA
5
V_O1 = V_O2 = V_CC = 5.5 V
I_CCH
0.05 4
µA
I_F1 = I_F2 = 0 mA
V_O1 = V_O2 = Open,
V_CC = 5.5 V
V_R
5
V
I_F = 10 µA, T_A = 25°C
5
Input Capacitance
C_IN
Input-Output
I_I–O
Insulation Leakage
Current
Resistance
R_I–O
(Input–Output)
60
pF
f = 1 MHz, V_F = 0 V
5
1.0 µA
45% Relative Humidity,
7
t = 5s
V_I–O = 3000 Vdc,
T_A = 25°C
10¹²
Ω
V_I–O = 500 Vdc
7
Capacitance
C_I–O
0.6
pF
f = 1 MHz
7
(Input–Output)
Input–Input
I_I–I
Insulation Leakage
Current
Resistance
R_I–I
(Input–Input)
0.005
µA
45% Relative Humidity,
8
t = 5s
V_I–I = 500 Vdc
10¹¹
Ω
V_I–I = 500 Vdc
8
Capacitance
C_I–I
0.25
pF
f = 1 MHz
8
(Input–Input)
*All typicals at 25°C.
Notes:
  5. Each channel.
  6. Current Transfer Ratio is defined as the ratio of output collector current, I_O, to the forward LED input current, I_F, times 100%.
  7. Device considered a two-terminal device: Pins 1, 2, 3, and 4 shorted together and Pins 5, 6, 7, and 8 shorted together.
  8. Measured between pins 1 and 2 shorted together, and pins 3 and 4 shorted together.
  9. Common mode transient immunity in Logic High level is the maximum tolerable (positive) dV_CM/dt on the leading edge of the common mode
pulse V_CM, to assure that the output will remain in a Logic High state (i.e., V_O > 2.0 V). Common mode transient immunity in Logic Low level is
the maximum tolerable (negative) dV_CM/dt on the trailing edge of the common mode pulse signal, V_CM, to assure that the output will remain
in a Logic Low state (i.e., V_O < 0.8 V).
10. The 7.5 k load represents 1 LSTTL unit load of 0.36 mA and a 20 kΩ pull-up resistor.
11. The 4.7 k load represents 1 LSTTL unit load of 0.36 mA and an 8.2 kΩ pull-up resistor.