HCPL-316J-500E Datasheet, PDF (7/33 Pages) AVAGO TECHNOLOGIES LIMITED – 2.5 Amp Gate Drive Optocoupler with Integrated (VCE) Desaturation Detection and Fault Status Feedback

Regulatory Information
The HCPL-316J has been approved by the following organizations:
IEC/EN/DIN EN 60747-5-2
Approved under:
IEC 60747-5-5:1997 + A1:2002
EN 60747-5-2:2001 + A1:2002
DIN EN 60747-5-2 (VDE 0884 Teil 2):2003-01.
UL
Recognized under UL 1577, component recognition
program, File E55361.
CSA
Approved under CSA Component Acceptance Notice
#5, File CA 88324.
IEC/EN/DIN EN 60747-5-2 Insulation Characteristics*
Description
Installation classification per DIN VDE 0110/1.89, Table 1
for rated mains voltage ≤ 150 Vrms
for rated mains voltage ≤ 300 Vrms
for rated mains voltage ≤ 600 Vrms
for rated mains voltage ≤ 1000Vrms
Climatic Classification
Pollution Degree (DIN VDE 0110/1.89)
Maximum Working Insulation Voltage
Input to Output Test Voltage, Method b**
V_IORM x 1.875 = V_PR, 100% Production Test with t_m = 1 sec,
Partial Discharge < 5 pC
Input to Output Test Voltage, Method a**
V_IORM x 1.6 = V_PR, Type and Sample Test, t_m = 10 sec,
Partial Discharge < 5 pC
Highest Allowable Overvoltage** (Transient Overvoltage t_ini = 60 sec)
Safety-limiting values – maximum values allowed in the event of a failure,
also see Figure 2.
Case Temperature
Input Power
Output Power
Insulation Resistance at T_S, V_IO = 500 V
Symbol
V_IORM
V_PR
Characteristic
I - IV
I - IV
I - IV
I - III
55/100/21
2
1230
2306
Unit
V_PEAK
V_PEAK
V_PR
V_IOTM
1968
8000
V_PEAK
V_PEAK
T_S
175
°C
P_{S, INPUT}
400
mW
P_{S, OUTPUT} 1200
mW
R_S
>10⁹
Ω
*Isolation characteristics are guaranteed only within the safety maximum ratings which must be ensured by protective circuits in application.
Surface mount classification is class A in accordance with CECCOO802.
**Refer to the optocoupler section of the Isolation and Control Components Designer’s Catalog, under Product Safety Regulations section IEC/
EN/DIN EN 60747-5-2, for a detailed description of Method a and Method b partial discharge test profiles.
1400
1200
1000
P_S, OUTPUT
P_S, INPUT
800
600
400
200
0
0 25 50 75 100 125 150 175 200
T_S – CASE TEMPERATURE – °C
Figure 2. Dependence of safety limiting values on temperature.
7