DE2-115 Datasheet, PDF (80/116 Pages) Altera Corporation – The DE2-115 package contains all components needed to use the DE2-115 board in conjunction with a computer that runs the Microsoft Windows OS.

Finally, the YcrCb_to_RGB block converts the YcrCb data into RGB data output. The VGA
Controller block generates standard VGA synchronous signals VGA_HS and VGA_VS to enable
the display on a VGA monitor.
Figure 6-1 Block diagram of the TV box demonstration
„ Demonstration Setup, File Locations, and Instructions
• Project directory: DE2_115_TV
• Bit stream used: DE2_115_TV.sof or DE2_115_TV.pof
• Connect a DVD player’s composite video output (yellow plug) to the Video-In RCA jack (J12)
of the DE2-115 board. The DVD player has to be configured to provide:
o NTSC output
o 60Hz refresh rate
o 4:3 aspect ratio
o Non-progressive video
• Connect the VGA output of the DE2-115 board to a VGA monitor (both LCD and CRT type of
monitors should work)
• Connect the audio output of the DVD player to the line-in port of the DE2-115 board and
connect a speaker to the line-out port. If the audio output jacks from the DVD player are RCA
type, then an adaptor will be needed to convert to the mini-stereo plug supported on the
DE2-115 board; this is the same type of plug supported on most computers
• Load the bit stream into FPGA by execute the batch file ‘de2_115_tv.bat’ under
DE2_115_TV\demo_batch\ folder
• Press KEY0 on the DE2-115 board to reset the circuit
79