English
Language : 

EP2C5F256C6N Datasheet, PDF (65/168 Pages) Altera Corporation – Section I. Cyclone II Device Family Data Sheet
Cyclone II Architecture
Table 2–17. Cyclone II Supported I/O Standards & Constraints (Part 2 of 2)
I/O Standard
Differential HSTL-15 class I
or class II
Differential HSTL-18 class I
or class II
LVDS
RSDS and mini-LVDS (8)
LVPECL (9)
Type
Pseudo
differential (4)
Pseudo
differential (4)
Differential
Differential
Differential
VCCIO Level
Top & Bottom
I/O Pins
Side I/O Pins
Input
Output
CLK,
DQS
User I/O
Pins
CLK,
DQS
PLL_OUT
User I/O
Pins
(5) 1.5 V
v (7)
1.5 V (5) v
(6)
(5) 1.8 V
v
(6)
v (7)
1.8 V (5) v
v
(6)
(6)
2.5 V 2.5 V v
v
v
v
v
(5) 2.5 V
v
v
v
3.3 V/ (5)
2.5 V/
1.8 V/
v
v
1.5 V
Notes to Table 2–17:
(1) To drive inputs higher than VC C I O but less than 4.0 V, disable the PCI clamping diode and turn on the Allow
LVTTL and LVCMOS input levels to overdrive input buffer option in the Quartus II software.
(2) These pins support SSTL-18 class II and 1.8- and 1.5-V HSTL class II inputs.
(3) PCI-X does not meet the IV curve requirement at the linear region. PCI-clamp diode is not available on top and
bottom I/O pins.
(4) Pseudo-differential HSTL and SSTL outputs use two single-ended outputs with the second output programmed
as inverted. Pseudo-differential HSTL and SSTL inputs treat differential inputs as two single-ended HSTL and
SSTL inputs and only decode one of them.
(5) This I/O standard is not supported on these I/O pins.
(6) This I/O standard is only supported on the dedicated clock pins.
(7) PLL_OUT does not support differential SSTL-18 class II and differential 1.8 and 1.5-V HSTL class II.
(8) mini-LVDS and RSDS are only supported on output pins.
(9) LVPECL is only supported on clock inputs.
f
For more information on Cyclone II supported I/O standards, see the
Selectable I/O Standards in Cyclone II Devices chapter in Volume 1 of the
Cyclone II Device Handbook.
High-Speed Differential Interfaces
Cyclone II devices can transmit and receive data through LVDS signals at
a data rate of up to 640 Mbps and 805 Mbps, respectively. For the LVDS
transmitter and receiver, the Cyclone II device’s input and output pins
support serialization and deserialization through internal logic.
Altera Corporation
February 2007
2–53
Cyclone II Device Handbook, Volume 1