EPF10K100ARI240-3 Datasheet, PDF (49/128 Pages) Altera Corporation – Embedded Programmable Logic Device Family

FLEX 10K Embedded Programmable Logic Device Family Data Sheet
Table 24. EPF10K50V & EPF10K130V Device DC Operating Conditions Notes (6), (7)
Symbol
Parameter
Conditions
Min
Typ
V _IH
V _IL
V _OH
V _OL
I_I
I_OZ
I _CC0
High-level input voltage
2.0
Low-level input voltage
–0.5
3.3-V high-level TTL output
I _OH = –8 mA DC (8)
2.4
voltage
3.3-V high-level CMOS output I _OH = –0.1 mA DC (8)
voltage
V_CCIO – 0.2
3.3-V low-level TTL output
voltage
I _OL = 8 mA DC (9)
3.3-V low-level CMOS output I _OL = 0.1 mA DC (9)
voltage
Input pin leakage current
Tri-stated I/O pin leakage
current
V_I = 5.3 V to –0.3 V (10)
–10
V_O = 5.3 V to –0.3 V (10)
–10
V_CC supply current (standby) V_I = ground, no load
0.3
V_I = ground, no load (11)
10
Max Unit
5.75
V
0.8
V
V
V
0.45
V
0.2
V
10
µA
10
µA
10
mA
mA
Table 25. EPF10K50V & EPF10K130V Device Capacitance (12)
Symbol
Parameter
Conditions
Min
Max Unit
C_IN
C_INCLK
C_OUT
Input capacitance
Input capacitance on dedicated
clock pin
Output capacitance
V_IN = 0 V, f = 1.0 MHz
V_IN = 0 V, f = 1.0 MHz
V_OUT = 0 V, f = 1.0 MHz
10
pF
15
pF
10
pF
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input voltage is –0.5 V. During transitions, the inputs may undershoot to –2.0 V or overshoot to 5.75 V
for input currents less than 100 mA and periods shorter than 20 ns.
(3) Numbers in parentheses are for industrial-temperature-range devices.
(4) Maximum V_CC rise time is 100 ms. V_CC must rise monotonically.
(5) EPF10K50V and EPF10K130V device inputs may be driven before V_CCINT and V_CCIO are powered.
(6) Typical values are for T _A = 25° C and V_CC = 3.3 V.
(7) These values are specified under the EPF10K50V and EPF10K130V device Recommended Operating Conditions in
Table 23 on page 48.
(8) The I_OH parameter refers to high-level TTL or CMOS output current.
(9) The I_OL parameter refers to low-level TTL or CMOS output current. This parameter applies to open-drain pins as
well as output pins.
(10) This value is specified for normal device operation. The value may vary during power-up.
(11) This parameter applies to -1 speed grade EPF10K50V devices, -2 speed grade EPF10K50V industrial temperature
devices, and -2 speed grade EPF10K130V devices.
(12) Capacitance is sample-tested only.
Altera Corporation
49