AK4115 Datasheet, PDF (34/64 Pages) Asahi Kasei Microsystems – High Feature 192kHz 24bit Digital Audio Interface Transceiver

ASAHI KASEI
[AK4115]
„ Error Handing for RX (PSEL = “0”)
The followings nine events the INT0 and INT1 pins to trigger the interrupt condition. When the PLL is OFF (Clock
Operation Mode 1), INT0 and INT1 pins go to “L”.
1. UNLCK
: PLL unlock state detect
“1” when the PLL loses lock. The AK4115 loses lock when the time between two preambles is not
correct or when those preambles are not correct.
2. PAR
: Parity error or bi-phase coding error detection
“1” when parity error or bi-phase coding error is detected, updated every sub-frame cycle.
3. AUTO
: Non-Linear PCM or DTS-CD Bit Stream detection
The OR function of NPCM and DTSCD bits.is available at the AUTO bit.
4. VRX
: Validity flag detection
“1” when validity flag is detected. Updated every sub-frame cycle.
5. AUDION : Non-audio detection
“1” when the “AUDION” bit in recovered channel status indicates “1”. Updated every block cycle.
6. STC
: Sampling frequency or pre-emphasis information change detection
When either FS3-0 bit or PEM bit is changed, it maintains “1” during 1 sub-frame.
7. QINT
: U-bit Sync flag
“1” when the Q-subcode differs from the old one. Updated every sync code cycle for Q-subcode.
8. CINT
: Channel status sync flag
“1” when received C bit differs from the old one. Updated every block cycle.
9. DAT
: DAT Start ID detect
“1” when the category code indicates “DAT” and “DAT Start ID” is detected. When DCNT bit is
“1”, it does not indicate “1” even if “DAT Start ID” is detected again within “3841 x LRCK”.
When “DAT Start ID” is detected again after “3840 x LRCK” passed, it indicates “1”. When
DCNT bit is “0”, it indicates “1” every “DAT Start ID” detection.
MS0573-E-00
- 34 -
2006/12