82-000225-01 Datasheet, PDF (26/34 Pages) Analog Devices – ICE-100B Emulator Users Guide

Mechanical Specifications
dependant on the particular Analog Devices processor, as well as the delay
characteristics of the custom processor board.
To ensure that the custom board’s JTAG interface is designed and laid out
correctly, refer to Engineer-to-Engineer Note, Analog Devices JTAG Emu-
lation Technical Reference (EE-68), available from the Analog Devices Web
site. This document is a technical reference for implementing the JTAG
interface on your target.
Mechanical Specifications
The outer dimensions of the ICE-100B emulator are 2.99” x 0.785”. The
height of the JTAG connector (J1) is approximately 0.310”. The tallest
component on the top is 0.235”, and the tallest component on the bottom
is 0.045”. Refer to Figure 2-3.
Care must be taken when locating a custom target JTAG interface
connector, that no components are taller than about 0.15” if located
under the emulator.
 If there are any concerns that emulator components may short to
the target board, an insulator should be used to provide protection.
2-4
ICE-100B Emulator User’s Guide