82-000225-01 Datasheet, PDF (24/34 Pages) Analog Devices – ICE-100B Emulator Users Guide

Resetting the Target
PN: ADZS-ICE-100B
STAT
LED3
PWR
LED1
LED2
ICE-100B
a
Figure 2-1. LED Positions - Top of Emulator Board
Resetting the Target
When debugging remotely, the ability to reset the target can be very use-
ful. Reset the target via the software or by soldering a wire from the
ICE-100B emulator to the target.
To solder a wire from the ICE-100B emulator to the target:
• Two solder points labeled RESET (reference designator P3) are
located near the JTAG connector (J1) and USB connector (P1) on
the ICE-100B (see Figure 2-2).
• For an active low version (~RESET), solder a wire between the
square pad (pin 1) of P3 and ~RESET input signal of the target.
• For an active high version (RESET), solder a wire between the round
pad (pin 2) and RESET input signal of the target.
2-2
ICE-100B Emulator User’s Guide