82-000225-01 Datasheet, PDF (20/34 Pages) Analog Devices – ICE-100B Emulator Users Guide

Configurator Software
3. If the emulator is not connected to the target, connect the devices
as described in “Verifying Driver Installation and Attaching to an
Emulation Target”.
4. Invoke CrossCore Embedded Studio or VisualDSP++.
To power down the ICE-100B emulator:
1. Shut down (exit) CrossCore Embedded Studio or VisualDSP++.
2. Disconnect the USB cable between the emulator and the PC.
3. Power down the target board.
 The PWR LED (power LED) lights green when power is applied and
the board is not in hibernate state.
4. The emulator can now be removed from the target.
For custom processor boards still in design, refer to an Engineer-to-Engi-
neer Note, “Analog Devices JTAG Emulation Technical Reference (EE-68)”,
available from the Analog Devices Web site. This document is a technical
reference for implementing the JTAG interface on your target.
Now the emulator hardware is ready to be used in conjunction with CCES
or VisualDSP++ to debug a processor target system. Refer to “Configura-
tor Software” for more information.
Configurator Software
CrossCore Embedded Studio and VisualDSP++ development software
require a description of your platform (JTAG chain). The platform defini-
tion is necessary for the software to communicate with the hardware
through the emulator.
The VisualDSP++ and CCES include the target configurator utility to
configure and test your emulator hardware. The target configurator pro-
1-8
ICE-100B Emulator User’s Guide