ACE25Q400G Datasheet, PDF (43/46 Pages) ACE Technology Co., LTD. – 4M BIT SPI NOR FLASH Memory Series

ACE25Q400G
4M BIT SPI NOR FLASH Memory Series
AC Electrical Characteristics Table19
Symbol
Parameter
Min. Typ. Max. Unit.
fc Clock frequency for all instructions, except Read Data(03H) DC.
108 MHz
fR Clock freq. Read Data instruction(03H)
DC.
55
MHz
tCLH Serial Clock High Time
4
ns
tCLL
tCLCH
tCHCL
Serial Clock Low Time
Serial Clock Rise Time (Slew Rate)
Serial Clock Fall Time (Slew Rate)
4
0.1⁽¹⁾
0.1⁽¹⁾
ns
V/ns
V/ns
tSLCH /CS Active Setup Time
5
ns
tCHSH /CS Active Hold Time
5
ns
tSHCH /CS Not Active Setup Time
5
ns
tCHSL /CS Not Active Hold Time
5
ns
tSHSL /CS High Time（read/write）
20
ns
tSHQZ Output Disable Time
6
ns
tCLQX Output Hold Time
0
ns
tDVCH Data In Setup Time
2
ns
tCHDX Data In Hold Time
2
ns
tHLCH /Hold Low Setup Time (relative to Clock)
5
ns
tHHCH /Hold High Setup Time (relative to Clock)
5
ns
tCHHL /Hold High Hold Time (relative to Clock)
5
ns
tCHHH /Hold Low Hold Time (relative to Clock)
5
ns
tHLQZ /Hold Low To High-Z Output
6
ns
tHHQX /Hold Low To Low-Z Output
6
ns
tCLQV Clock Low To Output Valid
7
ns
tWHSL Write Protect Setup Time Before /CS Low
20
ns
tSHWL Write Protect Hold Time After /CS High
100
ns
tDP /CS High To Deep Power-Down Mode
0.1
µs
tRES1 ^{/CS High To Standby Mode Without Electronic Signature}
Read
3
µs
tRES2 /CS High To Standby Mode With Electronic Signature Read
1.5
µs
tSUS /CS High To Next Instruction After Suspend
tW Write Status Register Cycle Time
2
µs
10
15⁽²⁾
ms
tBP1 Byte Program Time (First Byte) (3)
5
10
µs
tBP2 Additional Byte Program Time (After First Byte) (3)
2.8
5
µs
tPP Page Programming Time
0.7
2.4
ms
tSE Sector Erase Time
60
300
ms
tBE Block Erase Time(32K Bytes/64K Bytes)
0.3/0.5 0.75/1.5 s
tCE Chip Erase Time
4
10
s
Note:
1. Tested with clock frequency lower than 50 MHz.
2. tW can be up to 45 ms at -40℃ during the characterization of the current design. It will be improved in the future design.
3. For multiple bytes after first byte within a page, tBPn = tBP1 + tBP2 * N, where N is the number of bytes programmed.
VER 1.2 43