|
ACE25C200G Datasheet, PDF (24/48 Pages) ACE Technology Co., LTD. – 2M BIT SPI NOR FLASH | |||
|
◁ |
ACE25C200G
2M BIT SPI NOR FLASH
Quad I/O Fast Read with âContinuous Read Modeâ
See Figure 14, the Fast Read Quad I/O command can further reduce instruction overhead through
setting the âContinuous Read Modeâ bits (M7-0) after the input Address bits (A23-0), The upper nibble
of the (M7-4) controls the length of the next Fast Read Quad I/O command through the inclusion or
exclusion of the first byte instruction code. The lower nibble bits of the (M3-0) are donât care (âxâ).
However, the IO pins should be high-impedance prior to the falling edge of the first data out clock. If
the âContinuous Read Modeâ bits M5-4 = (1,0), then the next Fast Read Quad I/O command (after /CS
is raised and then lowered) does not require the EBH instruction code, This reduces the command
sequence by eight clocks and allows the Read address to be immediately entered after /CS is
asserted low. If the âContinuous Read Modeâ bits M5-4 do not equal to (1,0), the next command (after
/CS is raised and then lowered) requires the first byte instruction code, thus returning to normal
operation. A âContinuous Read Modeâ Reset command can also be used to reset (M7-0) before
issuing normal commands (see Continuous Read Mode Reset (FFH or FFFFH)).
Figure 14 Quad I/O Fast Read Sequence Diagram (Previous command set M5-4 =10)
Figure 14
VER 1.1 24
|
▷ |