|
ACE25C160G Datasheet, PDF (16/36 Pages) ACE Technology Co., LTD. – Uniform SECTOR Dual and Quad Serial Flash | |||
|
◁ |
ACE25C160G
Uniform SECTOR Dual and Quad Serial Flash
Dual I/O Fast Read (BBH)
The Dual I/O Fast Read command is similar to the Dual Output Fast Read command but with the
capability to input the 3-byte address (A23-0) and a âContinuous Read Modeâ byte 2-bit per clock by
SI and SO, each bit being latched in during the rising edge of SCLK, then the memory contents are
shifted out 2-bit per clock cycle from SI and SO. The command sequence is shown in followed
Figure10. The first byte addressed can be at any location. The address is automatically incremented
to the next higher address after each byte of data is shifted out.
Dual I/O Fast Read With âContinuous Read Modeâ
The Dual I/O Fast Read command can further reduce command overhead through setting the
âContinuous Read Modeâ bits (M7-0) after the input 3-byte address (A23-A0). If the âContinuous
Read Modeâ bits (M7-0) =AXH, then the next Dual I/O Fast Read command (after CS# is raised and
then lowered) does not require the BBH command code. The command sequence is shown in
followed Figure11. If the âContinuous Read Modeâ bits (M7-0) are any value other than AXH, the next
command requires the first BBH command code, thus returning to normal operation. A âContinuous
Read Modeâ Reset command can be used to reset (M7-0) before issuing normal command.
Figure10. Dual I/O Fast Read Sequence Diagram (M7-0= 0XH or not AXH)
VER 1.5 16
|
▷ |