YGV628B Datasheet, PDF (11/26 Pages) YAMAHA CORPORATION – AVDP7 Advanced Video Display Processor 7

YGV628B






2) Clock
To AVDP7, a clock (dot clock) for a scan timing of monitor display, and for passing a display data, a clock (capture
clock) for capturing a digital image input, and a clock (system clock) which is used for other process are supplied
separately.
Please input a dot clock and a capture clock into GCK1IN pin and GCK2IN pin, and input a system clock into
SYCKIN pin.
Since there is no function of XTAL oscillation, be sure to input the clock which carried out the external oscillation.
● GCK1IN (Input Pin No.172)
● GCK2IN (Input Pin No.146)
- These are input pins of a dot clock and a capture clock.
- Be sure to input the 5MHz to 40MHz clock oscillated externally into these pins.
● SYCKIN (Input Pin No. 173)
- It is a system clock input pin. The reference clock for the built-in PLL is input.
- Be sure to input the 5MHz to 40MHz clock into SYCKIN.
● FILTER (Analog Pin No.176)
- It is the filter connection pin for built-in PLL used for a system clock oscillation.
- Please connect a resistor and a capacitor externally between PLLVSS pin and FILTER pin.
3) CPU Interface
● D15-0 (Input/Output Pin No. 39-42, 44, 45, 47-52, 54-57)
- It is a CPU data bus pin. It connects with an external data bus of CPU.
- Since these pins do not internally have a pull-up resistor, please make the pull-up outside of the device.
● A23-1(Input Pin No. 1-4, 6, 8-18, 21-27)
- It is a CPU address bus pin. It connects with an external address bus of CPU.
- Since these pins do not internally have a pull-up resistor, please make the pull-up outside of the device if
necessary.
● CS_N (Input Pin No.33)
- It is a chip select input pin.
- The chip select signals from CPU to register space or video memory space are input.
- Since this pin does not internally have a pull-up resistor, please make the pull-up outside of the device if
necessary.
- This signal is low active.
● RD_N (Input Pin No.30)
- It is a READ pulse input pin.
- The strobe signal for data read-out from CPU is input.
- Since this pin does not internally have a pull-up resistor, please make the pull-up outside of the device if
necessary.
- This signal is low active.
● WRH_N (Input Pin No.28)
● WRL_N (Input Pin No. 29)
- It is a WRITE pulse input pin. The strobe signal for data writing from CPU is input.
- Since these pins do not internally have a pull-up resistor, please make the pull-up outside of the device if
necessary.
-11-