|
X9258 Datasheet, PDF (12/22 Pages) Xicor Inc. – Quad Digital Controlled Potentiometers (XDCP) | |||
|
◁ |
X9258
ABSOLUTE MAXIMUM RATINGS
Temperature under bias ....................â65°C to +135°C
Storage temperature .........................â65°C to +150°C
Voltage on SDA, SCL or any address input
with respect to VSS..................................â1V to +7V
Voltage on V+ (referenced to VSS)......................... 10V
Voltage on V- (referenced to VSS)......................... -10V
(V+) â (V-).............................................................. 12V
Any VH/RH............................................................... V+
Any VL/RL................................................................. V-
Lead temperature (soldering, 10 seconds)........ 300°C
IW (10 seconds)................................................ ±15mA
COMMENT
Stresses above those listed under âAbsolute Maximum
Ratingsâ may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device (at these or any other conditions above those
listed in the operational sections of this speciï¬cation) is
not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device
reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Commercial
Industrial
Min.
0°C
â40°C
Max.
+70°C
+85°C
Device
X9258
X9258-2.7
Supply Voltage (VCC) Limits
5V ±10%
2.7V to 5.5V
ANALOG CHARACTERISTICS
(Over recommended operating conditions unless otherwise stated.)
Symbol
Parameter
End to end resistance tolerance
Power rating
IW
Wiper current
RW
Wiper resistance
RW
Wiper resistance
V+
Voltage on V+ Pin
X9258
X9258-2.7
V-
Voltage on V- Pin
X9258
X9258 -2.7
VTERM Voltage on any VH/RH or VL/RL pin
Noise
Resolution (4)
Absolute linearity (1)
Relative linearity (2)
Temperature coefficient of RTOTAL
Ratiometric Temperature Coefficient
CH/CL/CW Potentiometer Capacitance
Limits
Min. Typ. Max.
±20
50
±7.5
150 250
40 100
+4.5
+5.5
+2.7
+5.5
-5.5
-4.5
-5.5
-2.7
V-
V+
-120
0.6
±1
±0.6
±300
±20
10/10/25
Unit
%
mW
mA
â¦
â¦
V
V
V
dBV
%
MI(3)
MI(3)
ppm/°C
ppm/°C
pF
Test Conditions
25°C, each pot
Wiper current = ± 1mA
IW = ± 1mA @ V+ = 3V, V- = -3V
IW = ± 1mA @ V+ = 5V, V- = -5V
Ref: 1kHz
Vw(n)(actual)âVw(n)(expected)
Vw(n + 1)â[Vw(n) + MI]
See Circuit #3
REV 1.1.7 2/4/03
www.xicor.com
Characteristics subject to change without notice. 12 of 22
|
▷ |