W83194R-67B Datasheet, PDF (7/18 Pages) Winbond – 100MHZ 3-DIMM CLOCK FOR VIA MVP4

W83194R-67B
PRELIMINARY
Bytes sequence order for I²C controller :
Clock Address
A(6:0) & R/W
Ack
8 bits dummy
Command code
Ack
8 bits dummy
Byte count
Ack
Byte0,1,2...
until Stop
Set R/W to 1 when read back the data sequence is as follows :
Clock Address
A(6:0) & R/W
Ack
Byte 0
Ack
Byte 1
Ack
Byte2, 3, 4...
until Stop
8.3 SERIAL CONTROL REGISTERS
The Pin column lists the affected pin number and the @PowerUp column gives the default state at
true power up. "Command Code" byte and "Byte Count" byte must be sent following the
acknowledge of the Address Byte. Although the data (bits) in these two bytes are considered "don't
care", they must be sent and will be acknowledge. After that, the below described sequence
(Register 0, Register 1, Register 2, ....) will be valid and acknowledged.
8.3.1 Register 0: CPU Frequency Select Register (default = 0)
Bit
@PowerUp
Pin
Description
7
0
6
0
5
0
4
0
3
0
2
0
1
0
0
0
-
0 = ±0.25% Center type Spread Spectrum Modulation
1 = ±0.5% Center type Spread Spectrum Modulation
-
SSEL2 (for frequency table selection by software via I²C)
-
SSEL1 (for frequency table selection by software via I²C)
-
SSEL0 (for frequency table selection by software via I²C)
-
0 = Selection by hardware
1 = Selection by software I²C - Bit 2, 6:4
-
SSEL3 (for frequency table selection by software via I²C)
-
0 = Normal
1 = Spread Spectrum enabled
-
0 = Running
1 = Tristate all outputs
Publication Release Date: Dec.. 1999
-7-
Revision 0.50