W25Q32BV_13 Datasheet, PDF (53/78 Pages) Winbond – 3V 32M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI

W25Q32BV
7.2.32 Read Manufacturer / Device ID Dual I/O (92h)
The Manufacturer / Device ID Dual I/O instruction is an alternative to the Read Manufacturer/Device ID
instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID at 2x
speed.
The Read Manufacturer / Device ID Dual I/O instruction is similar to the Fast Read Dual I/O instruction.
The instruction is initiated by driving the /CS pin low and shifting the instruction code “92h” followed by a
24-bit address (A23-A0) of 000000h, 8-bit Continuous Read Mode Bits, with the capability to input the
Address bits two bits per clock. After which, the Manufacturer ID for Winbond (EFh) and the Device ID
are shifted out 2 bits per clock on the falling edge of CLK with most significant bits (MSB) first as shown in
Figure 30. The Device ID values for the W25Q32BV is listed in Manufacturer and Device Identification
table. If the 24-bit address is initially set to 000001h the Device ID will be read first and then followed by
the Manufacturer ID. The Manufacturer and Device IDs can be read continuously, alternating from one to
the other. The instruction is completed by driving /CS high.
/CS
CLK
Mode 3
Mode 0
DI
(IO₀)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Instruction (92h)
A23-16
A15-8
A7-0 (00h)
M7-0
6420642064206420
DO
(IO₁)
* ^{= MSB}
High Impedance
7531753175317531
*
*
*
*
/CS
CLK
DI
(IO₀)
DO
(IO₁)
23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38
IOs switch from
Input to Output
06420642064206420
17531753175317531
* MFR ID
* Device ID
* MFR ID
(repeat)
* Device ID
(repeat)
Mode 3
Mode 0
Note:
Figure 30. Read Manufacturer / Device ID Dual I/O Diagram
The “Continuous Read Mode” bits M7-0 must be set to Fxh to be compatible with Fast Read Dual I/O instruction.
- 53 -
Publication Release Date: October 04,2013
Revision I