W742E Datasheet, PDF (34/60 Pages) Winbond – 4 BIT MICROCONTROLLER

W742E/C811
5.18.2 Port Mode 1 Register (PM1)
The port mode 1 register is organized as 4-bit binary register (PM1.0 to PM1.3). PM1 can be used to
control the input/output mode of port RA. PM1 is controlled by the MOV PM1, #I instruction. The bit
description is as follows:
3210
PM1 w w w w
Note: W means write only.
Bit 0 = 0 RA.0 works as output pin; Bit 0 = 1 RA.0 works as input pin
Bit 1 = 0 RA.1 works as output pin; Bit 1 = 1 RA.1 works as input pin
Bit 2 = 0 RA.2 works as output pin; Bit 2 = 1 RA.2 works as input pin
Bit 3 = 0 RA.3 works as output pin; Bit 3 = 1 RA.3 works as input pin
At initial reset, port RA is input mode (PM1 = 1111B).
5.18.3 Port Mode 2 Register (PM2)
The port mode 2 register is organized as 4-bit binary register (PM2.0 to PM2.3). PM2 can be used to
control the input/output mode of port RB. PM2 is controlled by the MOV PM2, #I instruction. The bit
description is as follows:
3210
PM2 w w w w
Note: W means write only.
Bit 0 = 0 RB.0 works as output pin; Bit 0 = 1 RB.0 works as input pin
Bit 1 = 0 RB.1 works as output pin; Bit 1 = 1 RB.1 works as input pin
Bit 2 = 0 RB.2 works as output pin; Bit 2 = 1 RB.2 works as input pin
Bit 3 = 0 RB.3 works as output pin; Bit 3 = 1 RB.3 works as input pin
At initial reset, the port RB is input mode (PM2 = 1111B).
5.18.4 Port Mode 6 Register (PM6)
The port mode 6 register is organized as 4-bit binary register (PM6.0 to PM6.3). PM6 can be used to
control the input/output mode of port P0. PM6 is controlled by the MOV PM6, #I instruction. The bit
description is as follows:
3210
PM6 w w w w
Note: W means write only.
- 34 -