W49F002U Datasheet, PDF (1/23 Pages) Winbond – 256K X 8 CMOS FLASH MEMORY

W49F002U
256K × 8 CMOS FLASH MEMORY
GENERAL DESCRIPTION
The W49F002U is a 2-megabit, 5-volt only CMOS flash memory organized as 256K × 8 bits. The
device can be programmed and erased in-system with a standard 5V power supply. A 12-volt VPP is
not required. The unique cell architecture of the W49F002U results in fast program/erase operations
with extremely low current consumption (compared to other comparable 5-volt flash memory
products). The device can also be programmed and erased using standard EPROM programmers.
FEATURES
• Single 5-volt operations:
− 5-volt Read
− 5-volt Erase
− 5-volt Program
• Fast Program operation:
− Byte-by-Byte programming: 35 µS (typ.)
• Fast Erase operation: 100 mS (typ.)
• Fast Read access time: 70/90/120 nS
• Endurance: 10K cycles (typ.)
• Ten-year data retention
• Hardware data protection
• One 16K byte Boot Block with Lockout
protection
• Two 8K byte Parameter Blocks
• Two Main Memory Blocks (96K, 128K) Bytes
• Low power consumption
− Active current: 25 mA (typ.)
− Standby current: 20 µA (typ.)
• Automatic program and erase timing with
internal VPP generation
• End of program or erase detection
− Toggle bit
− Data polling
• Latched address and data
• TTL compatible I/O
• JEDEC standard byte-wide pinouts
• Available packages: 32-pin DIP and 32-pin
TSOP and 32-pin-PLCC
Publication Release Date: April 2000
-1-
Revision A2