W3E32M64S-XBX Datasheet, PDF (8/17 Pages) White Electronic Designs Corporation – 32Mx64 DDR SDRAM

White Electronic Designs
W3E32M64S-XBX
FIGURE 4 – CAS LATENCY
CLK
CLK
COMMAND
T0
READ
DQS
DQ
CLK
CLK
COMMAND
T0
READ
DQS
DQ
T1
T2 T2n T3 T3n
NOP
CL = 2
NOP
NOP
T1
T2 T2n T3 T3n
NOP
CL = 2.5
NOP
NOP
Burst Length = 4 in the cases shown
Shown with nominal tAC and nominal tDSDQ
DATA
TRANSITIONING DATA
DON'T CARE
FIGURE 5 – EXTENDED MODE
REGISTER DEFINITION
BA1 BA0 A12 A11 A10 A9 A8 A7 A6 A5 A4 A3 A2 A1 A0 Address Bus
01 11
Operating Mode
DS DLL
Extended Mode
Register (Ex)
E0
DLL
0
Enable
1
Disable
E1
Drive Strength
0
Normal
1
Reduced
E12 E11 E10 E9 E8 E7 E6 E5 E4 E3 E2
00000000000
-----------
E1, E0
Valid
-
Operating Mode
Reserved
Reserved
1. E14 and E13 must be "0, 1" to select the Extended Mode Register (vs. the base Mode Register)
2. The QFC function is not supported.
allowed as long as it does not interrupt the data transfer
in the current bank and does not violate any other timing
parameters. Input A10 determines whether one or all
banks are to be precharged, and in the case where only
one bank is to be precharged, inputs BA0, BA1 select the
bank. Otherwise BA0, BA1 are treated as “Don’t Care.”
Once a bank has been precharged, it is in the idle state and
must be activated prior to any READ or WRITE commands
being issued to that bank. A PRECHARGE command will
be treated as a NOP if there is no open row in that bank
(idle state), or if the previously open row is already in the
process of precharging.
AUTO PRECHARGE
AUTO PRECHARGE is a feature which performs the
same individual-bank PRECHARGE function described
above, but without requiring an explicit command. This is
accomplished by using A10 to enable AUTO PRECHARGE
in conjunction with a specific READ or WRITE command.
A precharge of the bank/row that is addressed with the
READ or WRITE command is automatically performed
upon completion of the READ or WRITE burst. AUTO
PRECHARGE is non persistent in that it is either enabled
or disabled for each individual READ or WRITE command.
The device supports concurrent auto precharge if the
command to the other bank does not interrupt the data
transfer to the current bank.
AUTO PRECHARGE ensures that the precharge is
initiated at the earliest valid stage within a burst. This
“earliest valid stage” is determined as if an explicit
precharge command was issued at the earliest possible
time, without violating tRAS (MIN).The user must not issue
another command to the same bank until the precharge
time (tRP) is completed.
BURST TERMINATE
The BURST TERMINATE command is used to truncate
READ bursts (with auto precharge disabled). The most
recently registered READ command prior to the BURST
TERMINATE command will be truncated. The open page
which the READ burst was terminated from remains
open.
July 2006
Rev. 3
8
White Electronic Designs Corporation • [phone] • www.wedc.com