BFC3366Y2 Datasheet, PDF (9/12 Pages) Vishay Siliconix – Interference Suppression Film Capacitors MKP Radial Potted Type

Not for New Design - Please refer to MKP338 6 Y2 (28114)
www.vishay.com
MKP336 6 Y2
Vishay BCcomponents
GROUP C INSPECTION REQUIREMENTS
D
SUB-CLAUSE NUMBER AND TEST
OR
ND
CONDITIONS
SUB-GROUP C1 COMBINED SAMPLE
OF SPECIMENS OF SUB-GROUPS
D
C1A AND C1B
4.11.6 Final measurements
Visual examination
PERFORMANCE REQUIREMENTS
No visible damage
Legible marking
Capacitance
|C/C|  5 % of the value measured in
4.11.1.
Tangent of loss angle
Increase of tan :
 0.008
Compared to values measured in 4.11.1.
SUB-GROUP C2
4.12 Damp heat steady state
Voltage proof
2250 V_DC; 1 min between term.
No permanent breakdown or flash-over
Insulation resistance
 50 % of values specified in section
“Insulation resistance” of this
specification
D
56 days, 40 °C, 90 % to 95 % RH no load
capacitance
4.12.1 Initial measurements
Capacitance
Tangent of loss angle at 10 kHz
4.12.3 Final measurements
Visual examination
No visible damage
Legible marking
Capacitance
|C/C|  5 % of the value measured in
4.12.1.
Tangent of loss angle
Increase of tan :
 0.007
Compared to values measured in 4.12.1.
SUB-GROUP C3
4.13.1 Initial measurements
Voltage proof
2250 V_DC; 1 min between term.
Insulation resistance
D
Capacitance
Tangent of loss angle at 10 kHz
No permanent breakdown or flash-over
 50 % of values specified in section
“Insulation resistance” of this
specification
4.13 Impulse voltage
3 successive impulses, full wave, peak
voltage:
5 kV
Max. 24 pulses
No selfhealing breakdowns or flashover
4.14 Endurance
Duration: 1000 h
1.7 U_RAC at 105 °C
Once in every hour the voltage is
increased to 1000 V_RMS for 0.1 s via
resistor of 47  ± 5 %
Revision: 11-Dec-12
9
Document Number: 28115
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000