BFC3366Y2 Datasheet, PDF (7/12 Pages) Vishay Siliconix – Interference Suppression Film Capacitors MKP Radial Potted Type

Not for New Design - Please refer to MKP338 6 Y2 (28114)
www.vishay.com
MKP336 6 Y2
Vishay BCcomponents
INSPECTION REQUIREMENTS
General Notes
1. Sub-clause numbers of tests and performance requirements refer to the “ Sectional Specification, IEC-Publication
EN132400 (IEC 60384-14) and section one of this specification”.
2. In this table: D = Destructive
ND = Non destructive
GROUP C INSPECTION REQUIREMENTS
D
SUB-CLAUSE NUMBER AND TEST
OR
ND
SUB-GROUP C1A PART OF SAMPLE
OF SUB-GROUP C1
D
4.1 Dimensions (detail)
CONDITIONS
PERFORMANCE REQUIREMENTS
As specified in chapters “General data” of
this specification
Initial measurements
Capacitance
Tangent of loss angle at 10 kHz
4.3 Robustness of terminations
Tensile: Load 10 N; 10 s
Bending: Load 5 N; 4 x 90°
No visible damage
4.4 Resistance to soldering heat
No pre-drying
Method: 1A
Solder bath: 260 °C
Duration: 10 s
4.19 Component solvent resistance
Isopropylalcohol at room temperature
Method: 2
Immersion time: 5 min ± 0.5 min
Recovery time:
Min. 1 h, max. 2 h
4.4.2 Final measurements
Visual examination
No visible damage
Legible marking
Capacitance
|C/C|  5 % of the value measured
initially
Tangent of loss angle
Increase of tan : 0.008
Compared to values measured initially
SUB-GROUP C1B PART OF SAMPLE
OF SUB-GROUP C1
Initial measurements
Insulation resistance
D
Capacitance
Tangent of loss angle at 10 kHz
As specified in section “Insulation
Resistance” of this specification
4.20 Solvent resistance of the marking
Isopropylalcohol at room temperature
Method: 1
Rubbing material: Cotton wool
Immersion time: 5 min ± 0.5 min
No visible damage
Legible marking
4.6 Rapid change of temperature
A = - 55 °C
B = + 105 °C
5 cycles
4.6.1 Inspection
Duration t = 30 min
Revision: 11-Dec-12
7
Document Number: 28115
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000