AP561-F_15 Datasheet, PDF (15/17 Pages) TriQuint Semiconductor – 0.7-2.9 GHz 8W HBT Power Amplifier

Pin Configuration and Description
AP561-F
0.7-2.9 GHz 8W HBT Power Amplifier
Pin No.
1
2, 3, 7, 8, 12, 13
4, 5, 6
9, 10, 11
14
Backside Paddle
Label
PIN_V_BIAS
N/C
RF IN
RF Output / V_CC
PIN_V_PD
RF/DC GND
Description
Voltage supply for active bias for the amp. Connect to same supply voltage as Vcc.
No internal connection. This pin can be grounded or N/C on PCB. Land pads should be provided for PCB
mounting integrity.
RF Input. DC Voltage present, blocking cap required. Requires matching for operation.
RF Output. DC Voltage present, blocking cap required
Reference current into internal active bias current mirror. Current into PIN_VPD sets device quiescent
current. Also, can be used as on/off control.
Multiple Vias should be employed to minimize inductance and thermal resistance. Use recommended via
pattern shown under mounting configuration and ensure good solder attach for optimum thermal and
electrical performance
Evaluation Board PCB Information
TriQuint PCB 1069110 Material and Stack-up
Ultralam
1 oz. Cu top layer
0.0147 ± 0.0015
Finished Board
Thickness
Ultralam 2000
ε_r=2.5 typ.
1 oz. Cu bottom layer
TriQuint PCB 1080526 Material and Stack-up
FR4
1 oz. Cu top layer
0.021 ± 0.002
Finished Board
Thickness
Nelco N-4000-13
ε_r=3.7 typ.
Datasheet: Rev B 09-17-13
© 2013 TriQuint
1 oz. Cu bottom layer
- 15 of 17 -
Disclaimer: Subject to change without notice
www.triquint.com