AP561-F_15 Datasheet, PDF (10/17 Pages) TriQuint Semiconductor – 0.7-2.9 GHz 8W HBT Power Amplifier

AP561-F
0.7-2.9 GHz 8W HBT Power Amplifier
AP561-PCB2500 Evaluation Board (2500−2700 MHz)
R4
C2
C1
+
C12
D2
C13
R3
C14
R2
C15
D1
C6
C7
C10
C8
C11
U1
AP561
C16
C17
C18
C20
Notes:
1. See Evaluation Board PCB Information section for material and stack-up.
2. All components are of 0603 size unless stated on the schematic.
3. The right edge of C24 is placed at 85 mil from the AP561 RFin pin.
4. The left edge of C25 is placed at 55 mil from the AP561 RFout pin.
5. The left edge of C27 is placed at 175 mil from the AP561 RFout pin.
6. The DC bias feed is approximately a ¼ λ from output RF trace to C28.
7. Do not exceed 5.5V on Vpd or damage to D1 will occur. Do not exceed 13V on Vcc or damage to D2 will occur.
8. The primary RF microstrip line is 50. The RF trace is cut at component C21 for this particular reference design.
Bill of Material – AP561-PCB2500
Reference Des.
N/A
U1
C6, C16
C7, C10, C17
C8, C11, C18
C12
R1
R2
R3
C1, C20, C28
C23, C24, C25, C26
C2
C27
R4
D1
D2
Value
N/A
N/A
0.1 uF
1000 pF
100 pF
10 uF
200 Ω
330 Ω
10 kΩ
22 pF
1.2 pF
10 pF
0.6 pF
3.9 Ω
N/A
N/A
Description
Printed Circuit Board – Ultralam
0.7-2.9 GHz 8W Power Amplifier
CAP, 0603,10%, 50V, X7R
CAP, 0603, 5%, 50V, NPO
CAP, 0603, 5%, 50V, NPO
CAP, 1206, 10%, 15V, Tantalum
RES, 0805, 5%, 1/10W. Chip
RES, 0603,5%, 1/10W, Chip
RES, 0603, 5%,1/16W, Chip
CAP, 0603, 5%, 50V, NPO/COG
CAP, 0603, ± 0.05 pF, ACCU-P, 50V
CAP, 0603, 5%, 50V, NPO
CAP, 0603, ± 0.05 pF, ACCU-P, 50V
RES, 0603, 5%, 1/16W, Chip
TVS Diode Array, 5V, SOT23, 2Ch
Diode TVS, 13V
Manuf. Part Number
TriQuint
various
various
various
various
various
various
various
various
AVX
various
AVX
various
On-Semiconductor
On-Semiconductor
AP561-F
06035J1R2ABSTR
06035J0R6ABSTR
SM05T1G
1SMA33AT3G
Datasheet: Rev B 09-17-13
© 2013 TriQuint
- 10 of 17 -
Disclaimer: Subject to change without notice
www.triquint.com