TGS2354_15 Datasheet, PDF (10/11 Pages) TriQuint Semiconductor – 0.5-6.0 GHz 40 Watt GaN Switch

TGS2354
0.5-6.0 GHz 40 Watt GaN Switch
Assembly Notes
Component placement and adhesive attachment assembly notes:
• Vacuum pencils and/or vacuum collets are the preferred method of pick up.
• Air bridges must be avoided during placement.
• The force impact is critical during auto placement.
• Organic attachment (i.e., conductive epoxy) can be used in low-power applications.
• Curing should be done in a convection oven; proper exhaust is a safety concern.
Reflow process assembly notes:
• Use AuSn (80/20) solder and limit exposure to temperatures above 300°C to 3-4 minutes, maximum.
• An alloy station or conveyor furnace with reducing atmosphere should be used.
• Do not use any kind of flux.
• Coefficient of thermal expansion matching is critical for long-term reliability.
• Devices must be stored in a dry nitrogen atmosphere.
Interconnect process assembly notes:
• Thermosonic ball bonding is the preferred interconnect technique.
• Force, time, and ultrasonics are critical parameters.
• Aluminum wire should not be used.
• Devices with small pad sizes should be bonded with 0.0007-inch wire.
Datasheet: Rev - 07-23-14
© 2014 TriQuint
- 10 of 11 -
Disclaimer: Subject to change without notice
www.triquint.com