SLAU292C Datasheet, PDF (56/102 Pages) Texas Instruments – eZ430-Chronos™ Development Tool

Programming/Reprogramming the eZ430-Chronos Watch: Disassembly and Assembly of the Housing
www.ti.com
Figure 4-5. Metal Strips of Watch Housing and Buttons of Housing
CAUTION
Be careful when inserting the watch module. Do not push in the watch module
or tighten the screws without checking if the module is in position. The metal
strips of the buttons may get stuck at the buttons of the watch housing. If this
happens, gently push the strips towards the module with the screwdriver until
they slide over the buttons (see Figure 4-6).
Figure 4-6. Push Metal Strips Inward
3. Ensure that the gasket is in its position and replace the back with the screws again. Try using the
existing thread in the plastic housing and do not over tighten the screws.
56
eZ430-Chronos Hardware
SLAU292C – November 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated