SLAU292C Datasheet, PDF (29/102 Pages) Texas Instruments – eZ430-Chronos™ Development Tool

www.ti.com
eZ430-Chronos Control Center PC Software
3.3.3 SimpliciTI™ Sync
The SimpliciTI Sync tab offers the possibility setting time/date of the watch including calibration data
conveniently.
Pairing watch and PC:
1. Activate the pairing on the PC by clicking on "Start Access Point". The Control Center status line
displays "Access point started. Now start watch in ACC, PPT or synch mode" when the PC is ready
2. Select "SYnC" on the eZ430-Chronos watch by pushing the "#" button.
3. Initiate pairing on the watch by pushing the "DOWN" button to activate the selected mode. After a short
time, the link is established.
Setting the watch:
1. Select metric or imperial units
2. Enter calibration data for the temperature and altitude OR read back the data from the watch by
clicking on "Read Watch"
3. Click "Copy System Time" to set watch according to read the PC system time
4. Click "Set Watch" to transfer data to watch
5. The watch shows "DONE"
6. Push the "DOWN" button on watch to end connection
Figure 3-6. eZ430-Chronos Control Center Sync
SLAU292C – November 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated
eZ430-Chronos Software
29