SLAU292C Datasheet, PDF (100/102 Pages) Texas Instruments – eZ430-Chronos™ Development Tool

eZ430-RF Debug Interface
9. Verify correct properties of the port settings (see Figure B-8).
www.ti.com
Figure B-8. CC1111 Port Settings
B.2 eZ430-RF Debug Interface
1. Install an IDE of your choice (see Section 3.6), it contains the drivers for the debug interfaces
2. Connect the eZ430-RF USB Debug Interface to an USB port of the PC
3. Windows should now recognize the new hardware as an "MSP430 XXX x.xx.xx" (see Figure B-9). The
device name may be different from the one shown here.
Figure B-9. eZ430-RF Windows Driver Installation
4. The drivers are installed automatically without any user interaction.
5. The USB debug interface is installed and ready to use. The Windows Device Manager lists a new
entries for a Human Interface Device and the MSP430 Application UART (COMx) (see Figure B-10).
100 Detailed Hardware Driver Installation Guide
SLAU292C – November 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated