SLAU292C Datasheet, PDF (35/102 Pages) Texas Instruments – eZ430-Chronos™ Development Tool

www.ti.com
Data Logger PC Software
3.5.1 SimpliciTI Data Logger
The SimpliciTI Sync tab offers the possibility setting time/date of the watch including calibration data
besides reading out logged data.
Pairing watch and PC:
1. Activate the pairing on the PC by clicking on "Start Access Point". The eZ430-Chronos Data Logger
status line displays "Access point started. Now start watch in acc, ppt or sync mode" when the PC is
ready
2. Select "SYnC" on the eZ430-Chronos watch by pushing the "#" button (see detailed description in
Section 3.3.3).
3. Initiate pairing on the watch by pushing the "DOWN" button to activate the selected mode. After a short
time, the link is established
Setting the watch:
1. Select metric or imperial units.
2. Enter calibration data for the temperature and altitude OR read back the data from the watch by
clicking on "Read Watch"
3. Specify, which data should be logged
4. Define logging time interval (1 to 255 seconds), in which data is stored
5. Click "Copy System Time" to set watch according to read the PC's system time
6. Click "Set Watch" to transfer data to watch
7. The watch shows "DONE"
8. Push the "DOWN" button on watch to end connection
Reading out logged data:
1. Pair watch with PC in case not linked yet - see Pairing watch and PC above
2. Specify file name and location of log file
3. Click on "Download" to start data transfer
4. Push the "DOWN" button to stop connection when the transfer has finished.
The log file is stored in CSV format. Its content appears as one line per log. Each line starts with date,
time, heart rate, temperature, and altitude. Parameters which were not logged are set to zero (according
to settings in eZ430-Chronos Data Logger PC software).
SLAU292C – November 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated
eZ430-Chronos Software
35