|
LMH7220_14 Datasheet, PDF (5/34 Pages) Texas Instruments – LMH7220 High Speed Comparator with LVDS Output | |||
|
◁ |
LMH7220
www.ti.com
SNOSAL3E â SEPTEMBER 2006 â REVISED MAY 2013
+5V DC ELECTRICAL CHARACTERISTICS
Unless otherwise specified, all limits specified for TJ = 25°C, VCM = 300 mV, â50 mV < VID < +50 mV and RL = 100â¦.
Boldface limits apply at the temperature extremes. (1)(2)
Symbol
Parameter
Conditions
Min (1)
Typ (3)
Max (1)
Units
IB
Input Bias Current
VIN Differential = 0
â5
â7
â1.5
â0.5
µA
IOS
TC IOS
VOS
TC VOS
VRI
CMRR
PSRR
Input Offset Current
Input Offset Current TC
Input Offset Voltage
Input Offset Voltage TC
Input Voltage Range
Common-Mode Rejection Ratio
Power Supply Rejection Ratio
VIN Differential = 0
VIN Differential = 0
CMRR > 50 dB
VCM = 0 to VCCâ2.2V
â500
â9.5
â0.2
60
63
+500
nA
±2
nA/°C
+9.5
mV
± 50
μV/°C
VCCâ2
V
70
dB
74
dB
AV
VO
ÎVO
VOH
VOL
VOD
ÎVOD
ISC
IS
Open Loop Gain
Output Offset Voltage
VO Change Between â0â and â1â
Output Voltage High
Output Voltage Low
Output Voltage Differential
VOD Change between â0â to â1â
Short Circuit Current Output to GND
Pin (4)
Output Shorted Together (4)
Supply Current
VIN Differential = 50 mV
VIN Differential = ±50 mV
VIN Differential = 50 mV
VIN Differential = 50 mV
VIN Differential = 50 mV
VIN Differential = ±50 mV
OUT Q to GND Pin
VIN Differential = 50 mV
OUT Q to GND Pin
VIN Differential = 50 mV
OUT Q to OUT Q
VIN Differential = 50 mV
Load Current Excluded
VIN Differential = 50 mV
59
dB
1125
1217
1325
mV
â25
+25
mV
1380
1475
mV
925
1060
mV
250
320
400
mV
â25
+25
mV
5
5
mA
5
6.8
9
12.6
mA
(1) All limits are specified by testing or statistical analysis.
(2) Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very
limited self-heating of the device such that TJ = TA. No specification of parametric performance is indicated in the electrical tables under
conditions of internal self heating where TJ > TA. See APPLICATION INFORMATION for information on temperature de-rating of this
device.
(3) Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values may vary
over time and will also depend on the application and configuration. The typical values are not tested and are not ensured on shipped
production material.
(4) Applies to both single-supply and split-supply operation. Continuous short circuit operation at elevated ambient temperature can result in
exceeding the maximum allowed junction temperature of 150°C.
Copyright © 2006â2013, Texas Instruments Incorporated
Product Folder Links: LMH7220
Submit Documentation Feedback
5
|
▷ |