RM48L930 Datasheet, PDF (48/147 Pages) Texas Instruments – RM48Lx30 16/32-Bit RISC Flash Microcontroller

RM48L930
RM48L730
RM48L530
SPNS176 – SEPTEMBER 2011
www.ti.com
4.3 Power Sequencing and Power On Reset
4.3.1 Power-Up Sequence
There is no timing dependency between the ramp of the VCCIO and the VCC supply voltage. The
power-up sequence starts with the I/O voltage rising above the minimum I/O supply threshold, (see
Table 4-4 for more details), core voltage rising above the minimum core supply threshold and the release
of power-on reset. The high frequency oscillator will start up first and its amplitude will grow to an
acceptable level. The oscillator start up time is dependent on the type of oscillator and is provided by the
oscillator vendor. The different supplies to the device can be powered up in any order.
The device goes through the following sequential phases during power up.
Table 4-3. Power-Up Phases
Oscillator start-up and validity check
eFuse autoload
Flash pump power-up
Flash bank power-up
Total
1032 oscillator cycles
1180 oscillator cycles
688 oscillator cycles
617 oscillator cycles
3517 oscillator cycles
The CPU reset is released at the end of the above sequence and fetches the first instruction from address
0x00000000.
48
System Information and Electrical Specifications
Copyright © 2011, Texas Instruments Incorporated
Submit Documentation Feedback
focus.ti.com: RM48L930 RM48L730 RM48L530