MSP430FR5739-EP_16 Datasheet, PDF (1/95 Pages) Texas Instruments – Mixed-Signal Microcontrollers

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
MSP430FR5739-EP
SLVSCN6A – NOVEMBER 2014 – REVISED DECEMBER 2014
MSP430FR5739-EP Mixed-Signal Microcontrollers
1 Device Overview
1.1 Features
1
• Embedded Microcontroller
– 16-Bit RISC Architecture up to 24-MHz Clock
– Wide Supply Voltage Range (2 to 3.6 V)
– –55°C to 85°C Operation
• Optimized Ultra-Low-Power Modes
– Active Mode: 81.4 µA/MHz (Typical)
– Standby (LPM3 With VLO): 6.3 µA (Typical)
– Real-Time Clock (LPM3.5 With Crystal): 1.5 µA
(Typical)
– Shutdown (LPM4.5): 0.32 µA (Typical)
• Ultra-Low-Power Ferroelectric RAM (FRAM)
– Up to 16KB of Nonvolatile Memory
– Ultra-Low-Power Writes
– Fast Write at 125 ns per Word (16KB in 1 ms)
– Built-In Error Correction Coding (ECC) and
Memory Protection Unit (MPU)
– Universal Memory = Program + Data + Storage
– 10¹⁵ Write Cycle Endurance
– Radiation Resistant and Nonmagnetic
• Intelligent Digital Peripherals
– 32-Bit Hardware Multiplier (MPY)
– Three-Channel Internal DMA
– Real-Time Clock (RTC) With Calendar and
Alarm Functions
– Five 16-Bit Timers With up to Three
Capture/Compare Registers
– 16-Bit Cyclic Redundancy Checker (CRC)
• High-Performance Analog
– 16-Channel Analog Comparator With Voltage
Reference and Programmable Hysteresis
– 14-Channel 10-Bit Analog-to-Digital Converter
With Internal Reference and Sample-and-Hold
• 200 ksps at 100-µA Consumption
• Enhanced Serial Communication
– eUSCI_A0 and eUSCI_A1 Support:
• UART With Automatic Baud-Rate Detection
• IrDA Encode and Decode
• SPI at Rates up to 10 Mbps
– eUSCI_B0 Supports:
• I²C With Multiple Slave Addressing
• SPI at Rates up to 10 Mbps
– Hardware UART Bootstrap Loader (BSL)
• Power Management System
– Fully Integrated LDO
– Supply Voltage Supervisor for Core and Supply
Voltages With Reset Capability
– Always-On Zero-Power Brownout Detection
– Serial On-Board Programming With No External
Voltage Needed
• Flexible Clock System
– Fixed-Frequency DCO With Six Selectable
Factory-Trimmed Frequencies (Device
Dependent)
– Low-Power Low-Frequency Internal Clock
Source (VLO)
– 32-kHz Crystals (LFXT)
– High-Frequency Crystals (HFXT)
• Development Tools and Software
– Free Professional Development Environment
( Code Composer Studio™ IDE)
– Low-Cost Full-Featured Kit
(MSP-EXP430FR5739)
– Full Development Kit (MSP-FET430U40A)
– Target Board (MSP-TS430RHA40A)
• Family Members
– Variants and Available Packages Summarized
in
– For Complete Module Descriptions, See the
MSP430FR57xx Family User's Guide
(SLAU272)
• Supports Defense, Aerospace, and Medical
Applications
– Controlled Baseline
– One Assembly and Test Site
– One Fabrication Site
– Available in Extended (–55°C to 85°C)
Temperature Range
(Some Noted Parameters Specified for –40°C
to 85°C Only)
– Extended Product Life Cycle
– Extended Product-Change Notification
– Product Traceability
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.