TLC32040M Datasheet, PDF (9/30 Pages) Texas Instruments – ANALOG INTERFACE CIRCUIT

TLC32040M
ANALOG INTERFACE CIRCUIT
power-up sequence
To ensure proper operation of the AIC and as a safeguard against latch-up, it is recommended that a Schottky
diode with a forward voltage less than or equal to 0.4 V be connected from V_{CC –} to ANLG GND (see Figure 16).
In the absence of such a diode, power should be applied in the following sequence: ANLG GND and DGTL GND,
V_{CC –}, then V_{CC +} and V_DD. Also, no input signal should be applied until after power up.
AIC responses to improper conditions
The AIC has provisions for responding to improper conditions. These improper conditions and the response of
the AIC to these conditions are presented in Table 1 below.
AIC register constraints
The following constraints are placed on the contents of the AIC registers:
1. TA register must be ≥ 4 in WORD mode (WORD/BYTE = high).
2. TA register must be ≥ 5 in BYTE mode (WORD/BYTE = low).
3. TA’ register can be either positive, negative, or zero.
4. RA register must be ≥ 4 in WORD mode (WORD/BYTE = high).
5. RA register must be ≥ 5 in BYTE mode (WORD/BYTE = low).
6. RA’ register can be either positive, negative, or zero.
7. (TA register ± TA’ register) must be > 1.
8. (RA register ± RA’ register) must be > 1.
9. TB register must be > 1.
Table 1. AIC Responses to Improper Conditions
IMPROPER CONDITION
TA register + TA’ register = 0 or 1
TA register – TA’ register = 0 or 1
TA register + TA’ register < 0
RA register + RA’ register = 0 or 1
RA register – RA’ register = 0 or 1
RA register + RA’ register = 0 or 1
TA register = 0 or 1
RA register = 0 or 1
TA register < 4 in WORD mode
TA register < 5 in BYTE mode
RA register < 4 in WORD mode
RA register < 5 in BYTE mode
TB register = 0 or 1
RB register = 0 or 1
AIC and DSP cannot communicate
AIC RESPONSE
Reprogram TX Counter A with TA register value
MODULO 64 arithmetic is used to ensure that a positive value is loaded into the TX Counter A,
i.e., TA register + TA’ register + 40 HEX is loaded into TX Counter A.
Reprogram RX Counter A with RA register value
MODULO 64 arithmetic is used to ensure that a positive value is loaded into the RX Counter
A, i.e., RA register + RA’ register + 40 HEX is loaded into RX Counter A.
AIC is shutdown.
The AIC serial port no longer operates.
Reprogram TB register with 24 HEX
Reprogram TB register with 24 HEX
Hold last DAC output
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
4–9