THS7313 Datasheet, PDF (44/48 Pages) Texas Instruments – 3-Channel Low Power SDTV Video Amplifier with I2C Control, 6-dB Gain, SAG Correction, 2:1 Input MUX, and Selectable Input Bias Modes

THS7313
SLOS483 – NOVEMBER 2005
www.ti.com
Table 5. EVM WARNINGS AND RESTRICTIONS
It is important to operate this EVM within the input voltage and the output voltage ranges as specified in the
table below.
Input Range, V_S
Input Range, V_I
Output Range, V_O
2.7 V to 5 V
0 V to 3 V NOT TO EXCEED VS+ or
VS-
0 V to 5 V NOT TO EXCEED VS+ or
VS-
Exceeding the specified input range may cause unexpected operation and/or irreversible damage to the EVM. If
there are questions concerning the input range, please contact a TI field representative prior to connecting the
input power.
Applying loads outside of the specified output range may result in unintended operation and/or possible
permanent damage to the EVM. Please consult the EVM User's Guide prior to connecting any load to the EVM
output. If there is uncertainty as to the load specification, please contact a TI field representative.
During normal operation, some circuit components may have case temperatures greater than 100°C. The EVM
is designed to operate properly with certain components above 100°C as long as the input and output ranges
are maintained. These components include but are not limited to linear regulators, switching transistors, pass
transistors, and current sense resistors. These types of devices can be identified using the EVM schematic
located in the EVM User's Guide. When placing measurement probes near these devices during operation,
please be aware that these devices may be very warm to the touch.
Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265
Copyright © 2005, Texas Instruments Incorporated
44