71M6511 Datasheet, PDF(27/95 Page) Teridian Semiconductor Corporation

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

71M6511 Datasheet, PDF (27/95 Pages) Teridian Semiconductor Corporation – Single-Phase Energy Meter IC

◁

71M6511/71M6511H

Single-Phase Energy Meter IC

DATA SHEET

AUGUST 2007

Refreshing the WD Timer: The watchdog timer must be refreshed regularly to prevent the reset request signal from becoming

active. This requirement imposes an obligation on the programmer to issue two instructions. The first instruction sets WDT and

the second instruction sets SWDT. The maximum delay allowed between setting WDT and SWDT is 12 clock cycles. If this

period has expired and SWDT has not been set, WDT is automatically reset, otherwise the watchdog timer is reloaded with the

content of the WDTREL register and WDT is automatically reset. Since the WDT requires exact timing, firmware needs to be

designed with special care in order to avoid unwanted WDT resets. TERIDIAN strongly discourages the use of the software

WDT.

Special Function Registers for the WD Timer

Interrupt Enable 0 Register (IEN0):

MSB

LSB

EAL

WDT

ET2

ES0

ET1

EX1

ET0

EX0

Table 26: The IEN0 Register (see also Table 34)

Bit

IEN0.6

Symbol

WDT

Function

Watchdog timer refresh flag.

Set to initiate a refresh of the watchdog timer. Must be set directly before SWDT

is set to prevent an unintentional refresh of the watchdog timer. WDT is reset by

hardware 12 clock cycles after it has been set.

Table 27: The IEN0 Bit Functions (see also Table 34)

Note: The remaining bits in the IEN0 register are not used for watchdog control

Interrupt Enable 1 Register (IEN1):

MSB

LSB

EXEN2 SWDT EX6

EX5

EX4

EX3

EX2

Table 28: The IEN1 Register (see also Tables 35/36)

Bit

Symbol Function

IEN1.6

SWDT

Watchdog timer start/refresh flag.

Set to activate/refresh the watchdog timer. When directly set after setting WDT, a

watchdog timer refresh is performed. Bit SWDT is reset by the hardware 12 clock

cycles after it has been set.

Table 29: The IEN1 Bit Functions (see also Tables 35/36)

Note: The remaining bits in the IEN1 register are not used for watchdog control

Page: 27 of 95

V2.6

▷