71M6511 Datasheet, PDF (20/95 Pages) Teridian Semiconductor Corporation – Single-Phase Energy Meter IC

71M6511/71M6511H
Single-Phase Energy Meter IC
DATA SHEET
AUGUST 2007
Port Registers: The I/O ports are controlled by Special Function Registers P0, P1, and P2. The contents of the SFR can be
observed on corresponding pins on the chip. Writing a ‘1’ to any of the ports (see Table 11) causes the corresponding pin to be
at high level (V3P3), and writing a ‘0’ causes the corresponding pin to be held at low level (GND). The data direction registers
DIR0, DIR1, and DIR2 define individual pins as input or output pins (see section On-Chip Resources – DIO Ports for details).
Register
P0
DIR0
P1
DIR1
P2
DIR2
SFR R/W Description
Address
0x80 R/W Register for port 0 read and write operations (pins DIO4…DIO7)
0xA2
R/W Data direction register for port 0. Setting a bit to 1 means that the corresponding pin is
an output.
0x90 R/W Register for port 1 read and write operations (pins DIO8…DIO14)
0x91 R/W Data direction register for port 1.
0xA0 R/W Register for port 2 read and write operations (pins DIO17)
0xA1 R/W Data direction register for port 2.
Table 11: Port Registers
All four ports on the chip are bi-directional. Each of them consists of a Latch (SFR ‘P0’ to ‘P3’), an output driver, and an input
buffer, therefore the MPU can output or read data through any of these ports. Even if a DIO pin is configured as an output, the
state of the pin can still be read by the MPU, for example when counting pulses issued via DIO pins that are under CE control.
Special Function Registers Specific to the 71M6511
Table 12 shows the location and description of the 71M6511-specific SFRs.
Register
ERASE
PGADDR
EEDATA
EECTRL
Alternative
SFR
R/W Description
Name
Address
FLSH_ERASE 0x94
W _{This register is used to initiate either the Flash Mass Erase cycle or}
the Flash Page Erase cycle. Specific patterns are expected for
FLSH_ERASE in order to initiate the appropriate Erase cycle (default
= 0x00).
0x55 – Initiate Flash Page Erase cycle. Must be proceeded by a write
to FLSH_PGADR @ SFR 0xB7.
0xAA – Initiate Flash Mass Erase cycle. Must be proceeded by a
write to FLSH_MEEN @ SFR 0xB2 and the debug port must
be enabled.
FLSH_PGADR 0xB7
Any other pattern written to FLSH_ERASE will have no effect.
R/W _{Flash Page Erase Address register containing the flash memory page}
address (page 0 thru 127) that will be erased during the Page Erase
cycle (default = 0x00).
0x9E
0x9F
Must be re-written for each new Page Erase cycle.
R/W I2C EEPROM interface data register
R/W I2C EEPROM interface control register. If the MPU wishes to write a
byte of data to EEPROM, it places the data in EEDATA and then
writes the ‘Transmit’ code to EECTRL. The write to EECTRL initiates
the transmit sequence. See the section I2C Interface (EEPROM) for
a description of the command and status bits available for EECTRL.
Page: 20 of 95
© 2005-2007 TERIDIAN Semiconductor Corporation
V2.6