408-10390 Datasheet, PDF (6/18 Pages) TE Connectivity Ltd – Ocean side-feed applicators are available with either a mechanical feed, air feed, or servo feed system

408-10390
NOTE
Batteries Directive 2006/66/EC introduces new requirements from September 2008 concerning removability of batteries from
waste equipment in EU Member States. To comply with this Directive, this device is designed to allow the data chip to be
easily removed by the end-user when it needs to be replaced.
NOTE
Always dispose of the old data chip in an environmentally responsible way in accordance with local waste regulations. Contact
local authority for battery recycling locations.
The servo feed applicator works in conjunction with the AMPOMATOR* III servo terminator (or any machine
that incorporates the TE precision controller) to form a complete system that allows setup and operation. The
information on the data chip is listed in the three separate groups:
— applicator data
— terminal data
— maintenance data
A significant amount of the data is reference data to aid in the setup of the machine and inspection of the final
crimp.
2.4. Applicator with Non-Servo Feed System
As with the data chip on the servo feed latch plate, optional data chip kit PN 2161326-[ ] also allows storage for
key operating parameters and contains reference data that can be useful for other machine setup and crimp
inspection. It requires compatible terminating equipment. For complete description of the data chip, refer to
409–10073.
2.5. Applicator with Non-Adjust Head
With this applicator, all wire crimp height adjustments are made by the machine. When built in the factory, the
applicator's non-adjust head is shimmed so that the applicator will crimp its assigned terminal to the largest
wire crimp height found on the applicator log while the terminating machine is set to normal shut height.
NOTE
If using an applicator with a fine-adjust head on a machine with a self-adjusting wire crimp height feature, always set the
fine-adjust head to the largest wire crimp height called out on the applicator log.
2.6. Applicator with Pacific Head
The Pacific applicator will only work in conjunction with a machine having a ram that falls within the envelope
shown in Figure 7.
Note: Dimensions are in millimeters
with inches in brackets.
⌀ 20.40 [.803]
Max
⌀ 27.70 [1.091]
Max
⌀ 41.90 [1.650]
Max
Figure 7
13.50 [.531]
Min
16.70 [.657]
Min
7.99 [.315] Min
4.50 [.177] Max
Rev M1
6 of 18